Loading ...
Loading ...
Loading ...
Burner Electrode and Igniter Cover
□ Place the 5 burner electrode wires (thin black ), the ground wire (red capped) and the igniter
wire (large black) through the pre-installed side panel clamp. See A. Note: If wires are
difficult to install, loosen the clamp screw, put the wires through the clamp and retighten the
screw.
□ Place the 5 thin black wire into the 5 narrow slots in the electronic ignition module. Place the
red capped ground wire into the slot outlined in orange. Place the large black wire into the
wide slot. See B
□ Attach the igniter cover with (2) M4x10 screws. See C (Note: If cover is hard to install, use a
screwdriver to press down on the right door heel hook to remove the door. Install the cover,
and reattach door.) See D
A
B
C
• 23
M4X10 screw Qty: 2 pcs
D
Loading ...
Loading ...
Loading ...