61004108 LPG OWNER’S MANUAL

Loading ...

Troubleshooting

m WARNING: Do not attempt to make any

repair to gas carrying, gas burning, ignition

components or structural components without

contacting Weber-Stephen Products LLC,

Customer Service Department.

m WARNING: Failure to use genuine Weber-

Stephen parts for any repair or replacement

will void all warranty protection.

Lighting Your Grill with a Match

Using a Match to Determine if there is

Gas Flow to the Main Burners

1) Open the grill lid.

2) Check that all burner control knobs (including side

burner control knob) are in the o

position. Check

by pushing in and turning knobs clockwise.

Note: It is important that all burner control knobs

are in the o position before turning on the LPG

cylinder.

3) Turn gas supply on by turning cylinder valve

anti-clockwise or by moving regulator lever to the

onposition depending on your regulator/cylinder

connection.

4) Begin with the burner furthest to the left. Put

match in the matchstick holder and strike match.

(Matchstick holder is located under right side

table.) Insert lit match down through the cooking

grates, past the Flavorizer™ bars and next to the

burner(A).

5) Pushthe burner control knob in and slowly turn it

anti-clockwise toward the ignite

position until

you hear ticking. Once ticking starts, hold the knob

in that position for 1-2 seconds and then slowly

continue turning anti-clockwise. The burner should

ignite before the high+ position.

6) Check that the burner is lit by looking through the

cooking grates and through the half-circle cutout in

the Flavorizer™ bar.

7) If the burner does not ignite within 4 seconds,

turn burner control knob to the o

position and

wait ﬁve minutes to allow the gas to clear before

attempting to light the burner again. If repeated

attempts fail, follow the gas ﬂow troubleshooting

instructions on the next page.

8) If the burner ignites, the problem lies in the ignition

system. Follow the instructions for “Checking the

Components of the Electronic Ignition System”.

9) Replace the matchstick holder by hanging

underneath right side table (B).

Using a Match to Determine if there is

Gas Flow to the Side Burner

1) Open the side burner lid.

2) Check that the side burner control knob is in the

o position. Check by pushing in and turning knob

clockwise. Also check that all main burner control

knobs are in the o

position.

Note: It is important that all burner control knobs

are in the o

position before turning on the LPG

cylinder.

3) Turn gas supply on by turning cylinder valve

anti-clockwise or by moving regulator lever to the

onposition depending on your regulator/cylinder

connection.

4) Put match in the matchstick holder and strike

match. (Matchstick holder is located under right

side table.) Hold lit match by the side burner(C).

5) Pushthe side burner control knob in and slowly

turn it anti-clockwise toward the ignite

position

until you hear ticking. Once ticking starts, hold

the knob in that position for 1-2 seconds and then

slowly continue turning anti-clockwise. Theburner

should ignite at the high position.

6) Check that the side burner is lit. The side burner

ﬂame may be dicult to see on a bright sunny day.

7) If the side burner does not ignite within 4 seconds,

turn side burner control knob to the o position

and wait ﬁve minutes to allow the gas to clear

before attempting to light the burner again.

If repeated attempts fail, follow the gas ﬂow

troubleshooting instructions on the next page.

8) If the burner ignites, follow the instructions for

“Checking the Components of the Electronic Ignition

System”.

MAIN BURNERS or SIDE BURNER WILL NOT IGNITE

SYMPTOM

• Main burners or side burner do(es) not ignite when following the electronic ignition instructions in the “Operation” section of

this owner's manual.

CAUSE SOLUTION

There is a problem with gas ﬂow. If any burner does not ignite, the ﬁrst step is to determine if there is gas ﬂowing to the burner(s). Tocheck

this, follow the instructions below for “Lighting Your Grill with a Match.”

If match lighting IS NOT successful, follow the gas ﬂow troubleshooting suggestions on the next page.

There is a problem with the electronic ignition system. If any burner does not ignite, the ﬁrst step is to determine if there is gas ﬂowing to the burner(s). Tocheck this,

follow the instructions below for “Lighting Your Grill with a Match.”

If match lighting IS successful, follow the instructions below for “Checking the Components of the Electronic

IgnitionSystem.”

Loading ...

LPG OWNER’S MANUAL - Page 18