Loading ...
Loading ...
Loading ...
7
Leveling
WARNING: Level the enclosure before attempting to install equipment. The casters are not designed to provide long-term support for the
enclosure. Use the levelers to provide long-term support. Install the enclosure in a structurally sound area with a level floor that is able to
bear the weight of the enclosure, all equipment that will be installed in the enclosure and any other enclosures and/or equipment that will
be installed nearby.
Ground Connection
All the parts of the enclosure are grounded to the frame of the enclosure. Use the enclosure's front
or rear threaded grounding point
A
and an M6 screw (included) to connect the frame of the
enclosure directly to your facility's earth ground connection with an 8 AWG (3.264 mm) wire. Route
the ground wire under the enclosure's frame to ensure unhindered door operation. WARNING:
Attach each enclosure to earth ground separately. Do not use the enclosure without an
earth ground connection.
EARTH
GROUND
FLOOR
1
2
3
A
B
4
A
A
Enclosure Installation
1
After the enclosure has been moved to the installation location, use a carpenter's level to check
the slope of the floor. If the floor slopes more than 1%, choose an alternate installation site.
2
Use an 18 mm open-end wrench to lower each leveler
A
until it reaches the floor. (There are 4
levelers, 2 at the front and 2 at the rear.) Make sure each leveler contacts the floor solidly.
Note: Lower a leveler by turning it clockwise; raise a leveler by turning it counter-clockwise.
3
After lowering each leveler, use the carpenter's level to confirm that the enclosure is level in all
directions. Adjust the levelers as required until the enclosure is level.
4
In order to secure the cabinet to the building structure for stability, attach the 2 shipping
brackets using the hardware that attached the enclosure to the shipping pallet. Use a 13 mm
open-end wrench to connect the brackets to the outer
A
or inner
B
bracket mounting points of
the enclosure. Attach the brackets to secure mounting points in the floor using user-supplied
hardware or Tripp Lite's SmartRack Bolt-Down Kit (Model: SRBOLTDOWN).
Loading ...
Loading ...
Loading ...