Loading ...
Loading ...
Loading ...
2. Remove the chain cover nuts with the wrench.
3.
Remove the chain cover.
4. Put the chain drive links into the bar groove.
5. Put the chain cutters in the direction of the chain
operation.
6. Put the chain in position and make sure that the
loop is behind the guide bar.
7. Hold the chain and bar.
8. Put the chain loop around the sprocket.
9. Make sure the chain tension pin hole on the guide
bar fits correctly with the bolt.
10. Install the chain cover.
11. Tighten the chain. Refer to
Adjust the chain tension.
12. Tighten the nuts when the chain is well tensioned.
NOTE
If you start the chain saw with a new chain, have a test
for 2-3 minutes. After that, examine the tension again
and tighten the chain if necessary.
9.3 REMOVE THE BATTERY PACK
Figure 8
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9.4 INSTALL THE BATTERY PACK
Figure 8
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2.
Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
10 OPERATION
NOTE
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.
IMPORTANT
Examine the chain tension before each use.
10.1 START THE MACHINE
Figure 1.
1. Press the lock-out button.
2. Press the trigger while you hold the lock-out button.
3. Release the lock-out button.
IMPORTANT
If unit does not start, ensure chain brake is
disengaged.
10.2 STOP THE MACHINE
Figure 1.
1. Release the trigger to stop the machine.
10.3 PREPARE FOR CUTTING
Figure 9.
• Wear non-slip gloves for maximum grip and
protection.
• Hold the machine with hands tightly. Always keep
your left hand on the front handle and your right
hand on the rear handle. So your body is to the left
of the chain line.
• Hold the handles with the thumbs and the fingers
around them. It is dangerous If the thumb and
fingers are on the same side of the handle. Because
a slight kickback of the machine can cause loss of
control.
WARNING
Do not let any part of your body to be in the chain line
while you operate the machine.
WARNING
Do not use a lefthanded (cross-handed) grip or any
stance that can put your body or arm across the chain
line.
10.4 BASIC OPERATION PROCEDURES
Practice cutting a few small logs with the below
technique to get the “feel” of using the machine before
you begin a major operation.
•
Take the proper stance in front of the wood.
• Press the lock-out button and press the trigger, then
release the lock-out button and let the chain
increase to full speed before you enter the cut.
• Start your cut with the saw against the log.
• Keep a stable speed during operation.
• The chain will cut for you with only light downward
pressure. Force the machine to cut can result in
damage to the bar, chain, or motor.
9
English
EN
Loading ...
Loading ...
Loading ...