Loading ...
Loading ...
Loading ...
8
EN
Batteries and Power
This tool is powered by the following DeWALT 12V Battery packs:
DCB120, DCB127 or may also be powered using the DEWALT AA
Starter pack which can carry 4 x AA batteries. Note: The AA starter
pack is recommended only for use with the red laser.
Battery Installation / Removal
Using the AA Starter Pack:
CAUTION:
The AA starter pack is designed specifically for use only
with the DeWALT 12V compatible laser products and
cannot be used with any other tools Do not attempty to
modify the product.
To install batteries:
• Lift up the battery compartment cover as shown in Figure
6A
.
• Insert four fresh AA batteries in the compartment, placing
the batteries according to (+) and (–) on the inside of the
compartment.
• Install the AA starter Battery pack as shown in Figure
6B
.
Using the 12V DEWALT Rechargeable Pack:
• Install the 12V Battery pack as shown in
Figure
6B
.
WARNING:
Batteries can explode, or leak, and can cause
injury or fire. To reduce this risk:
• Carefully follow all instructions and warnings on the battery label
and package and accompanying Battery Safety Leaflet.
• Always insert batteries correctly with regard to polarity (+ and –),
marked on the battery and the equipment.
• Do not short battery terminals.
• Do not charge disposable batteries.
• Do not mix old and new batteries. Replace all of them at the same
time with new batteries of the same brand and type.
• Remove dead batteries immediately and dispose of per local
codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries when the device is not in use
• Use only the charger specified for your rechargeable battery pack.
Personal Safety
• Stay alert, watch what you are doing and use common sense when
operating a laser tool. Do not use tool while tired or under the
influence of drugs, alcohol, or medication. A moment of inattention
while operating power tools may result in serious personal injury.
• Use personal protective equipment. Always wear eye protection.
Protective equipment such as dust mask, non-skid safety shoes,
hard hat, or hearing protection used for appropriate conditions will
reduce personal injuries.
Service
• Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel could
result in a risk of injury.
• When servicing a tool, use only identical replacement parts.
Follow instructions in the Maintenance section of this manual. Use
of unauthorized parts or failure to follow Maintenance Instructions
may create a risk of electric shock or injury.
To locate your nearest DeWALT service center call 1-800-4-DeWALT
(1-800-433-9258) go to http://www.2helpU.com on the Internet.
Loading ...
Loading ...
Loading ...