Loading ...
Loading ...
Loading ...
32 / /40 EN
Operation of the product
Water cut-o warnng
If mains water is cut or water inlet tap is
turned off the machine cannot take water
in and P2 icon will flash on the programme
indicator. As long as the problem continues,
washing programme is paused and the
water inlet is checked regularly by the
machine; when the water is restored P2
icon will disappear after a while and the
washing programme resumes.
Overowng warnng
If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and P1
icon will flash on the Programme indicator.
As long as the overflowing continues safety
algorithm will be active and try to discharge
the water. If overflowing stops and safety
is assured, P1 icon will disappear. If P1 does
not disappear, there is a permanent fault. In
this case the authorised service should be
contacted.
End of programme
End of Programme indicator will light up
once the washing programme is over.
1. Press the On/Off key to turn off your
machine.
2. Close the tap.
3. Unplug the machine from the socket.
C
For energy saving, the machine
is automatically turned off
following the completion of the
programme or if the programme
is not started.
C
Leave your dishes in the
machine for about 15 minutes
to allow them cool down after
they are washed. Your dishes
will dry in a shorter time if you
leave the door of your machine
ajar during this period. This
process will increase the drying
effectiveness of your machine.
No rinse aid dispensed in P:1 position
1 dose of rinse aid is dispensed in P:2
position.
2 doses of rinse aid are dispensed in P:3
position.
3 doses of rinse aid are dispensed in P:4
position.
4 doses of rinse aid are dispensed in P:5
position.
Loading ...
Loading ...
Loading ...