Loading ...
Loading ...
Loading ...
/
31 / 40
EN
Operation of the product
C
Your machine performs water
softening depending on the
hardness level of the supply
water. Due to water softening
process the programme
duration may change. The
programme duration can also
change while the programme
is running depending on the
ambient temperature where
your machine is installed,
temperature of the supply
water and amount of the dishes.
C
Pay attention not to open the
door of the machine when it is
running. Stop the machine by
pressing Start/Pause/Cancel
key if you have to open the
door. Then, open the door of
the machine. There may be a
rush of vapour when you open
the door of your machine; be
careful. Close the door of your
machine and press Start/Pause/
Cancel key again. Programme
will resume running.
C
The machine will remain silent
in pause mode for some time
in order to remove the water in
the machine and on the dishes
completely and to have the
water softener cleaned, and
then it will resume running in
drying mode.
Cancellng the programme
1. Press Start/Pause/Cancel key for 3
seconds to cancel the programme.
2. Release the key when the programme
indicator starts flashing. For a couple
of minutes the machine will fulfill
the necessary operations required to
cancel the programme.
C
There might be residues of
detergent or rinse aid in the
machine and/or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Salt ndcator ( )
Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears
on the display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.
Rnse Ad ndcator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
Adjustng the amount of
rnse ad
1. After turning on the machine, press
and hold Time Delay and P keys
simultaneously for 3 seconds to enter
the settings menu.
2. Press P key until the drying indicator
starts flashing
3. Set to the appropriate level with the
Time Delay key.
4. Press the On/Off key to save.
Loading ...
Loading ...
Loading ...