Loading ...
Loading ...
Loading ...
9
To disengage lid from the lock position, fully extend
(rotate lid back) lid back and gently lift “lid-stay” up
as shown to disengage from the lock position.
Once the “lid-stay” is in the unlock position, the lid
can be lowered to the close position.
Alcohol Burner Operating Instructions
1. Completely open the flame control cap by rotating the control wheel to the left.
2. Ignite the small fiber wick located in the center chimney. A match may be used or a Bar-B-Que grill-
igniting wand is ideal. Do not leave matches in the center chimney; they will inhibit the efficiency of
the burner.
3. Allow for approximately two to five minutes for flames to appear in the burner jets (see theory of
operation) Cooking may be initiated immediately after ignition of the center chimney. This will not
effect the preheating of the main burner and automatic switch over to normal full operation.
CLOSING THE GLASS LID
If your KENYON
®
stove is equipped with a glass lid, care should be followed when lowering the lid onto
the stove. NEVER CLOSE THE LID ON AN OPEN FLAME OR AN ELECTRIC ELEMENT THAT IS
HOT OR TURNED “ON”. Make sure that the appliance is cool before lowering the glass lid onto the
frame.
When the lid is in an open position, the “lid-stay” arm that is attached to the glass “locks” onto the large
lock screw. In order to lower the glass lid onto the stove frame, the “lid-stay” must be unlocked from the
mounting screw. DO NOT TRY TO LOWER THE LID WITH THE “LID-STAY” IN THE LOCK
POSITION. FAILURE TO UNLOCK THE “LID-STAY” WHEN ATTEMPTING TO LOWER THE GLASS
LID CAN CAUSE DAMAGE TO THE APPLIANCE WHICH IS NOT COVERED UNDER WARRANTY.
Gently lift “lid-stay” up as shown to
disengage “lid-stay” from lock position.
Carefully lower the glass lid once “lid-stay”
is disengaged from the lock position.
“LID-STAY”
Lock Screw
Loading ...
Loading ...