Loading ...
Loading ...
Loading ...
2.Tightenthecompressionnut(B)ontothe
compressionfitting.
Donotover-tightenthecompressionnut(B).
3.Turnthewateronandcheckforanyleaks
insidetherefrigerator,aroundthewaterfilter,
andinanyconnectionareas.
Ifyoufindwaterdropsorleaks,turnoffthe
mainwatersupply.
Iftheleaksareintheconnectionareas,check
theconnectionsand,ifnecessary,tighten.
Ifthereareleaksintherefrigerator,check
thewaterfilterandconfirmitisinthelocked
position.
Turnonthewatersupplyandcheckforleaks
again.
4. Plugintherefrigerator.
5. Flush3gallonsofwaterthroughthefilterbefore
drinkingorusingthewaterfromtherefrigerator.
(Flushapproximately6minutes.)
Thiswillcleanthewatersupplysystemand
removeairfromthelines.
Toflush,presstheWaterbutton,andthenpress
alargeglassorcupagainstthewaterdispenser
lever.Filltheglass,emptyitintothekitchensink
afteritisfilled,andthenrepeat.
[_ dditionalflushingmayberequiredin
somehouseholds.
6. Opentherefrigeratordoorandmakesurethere
arenowaterleakscomingfromthewaterfilter.
o
o
o
After you turn on the refrigerator, let the
ice maker make ice for 1 to 2 days.
Over that period of time, throw out the
first 1 or 2 buckets of ice the ice maker
makes to ensure all impurities have been
removed from the water line.
Only connect the water line to a drinkable water
source.
If you have to repair or disassemble the water
line, cut off 1/4" of the plastic tubing to make
sure you get a snug, leak-free connection.
You can test the water line quickly using a
paper cup.
Under normal conditions, the water dispenser
can fill a 5.75 oz. (170 cc) cup in about 10
seconds.
COMPLETING THE SET UP
Now that you have your new refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
1. Make sure your refrigerator is in an appropriate
location with reasonable clearance between it
and the wall. Refer to installation instructions in
this manual.
2. Once the refrigerator is plugged in, make sure
the interior light comes on when you open the
doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour.
The freezer will get slightly chilled and the motor
will run smoothly.
Reset the refrigerator and freezer to the
temperatures you want.
4. After you plug the refrigerator in, it will
take a few hours to reach the appropriate
temperature.
You can store food and drinks in the refrigerator
after the temperature is sufficiently cool.
®
If condensation or water drops appear
on both sides of the fridge door's central
part, turn the Energy Saver mode off after
removing the condensation.
(See the explanation of the Energy Saver
button in "Using the Control Panel" on
page 18.)
Preventing Power Cord Damage
To prevent power cord damage, fix any excess
power cord to the top rear of the refrigerator as
shown in the illustration below.
' :
/_ i iiiiiiiii
y_/ [ /
Engl sh - 17
Loading ...
Loading ...
Loading ...