Loading ...
Loading ...
Loading ...
To assemble your tractor you will need:
t ___ (2) 7/16" wrenches Tire Pressure Gauge
(2) 9/16" wrenches Utility Knife
(1) 3/4" wrench
NOTE: RIGHT HAND (R.H.) AND LEFT HAND (L.H.) ARE
DETERMINED FROM OPERATOR'S POSITION WHILE
SEATED ON THE TRACTOR.
WEAR EYE AND FACE SHIELD,
WASH HANDS OR CLOTHING IM-
MEDIATELY IF ACCIDENTALLY IN
CONTACT WITH BATTERY ACID.
DO NOT SMOKE, FUMES FROM
CHARGED BATTERY ACID ARE
EXPLOSIVE.
READ THE INSTRUCTIONS INCLUD-
ED WITH THE BATTERY ACID CON-
TAINER. ALWAYS WEAR GLOVES,
CLOTHING AND GOGGLES TO PRO-
TECT YOUR HANDS, SKIN AND
EYES.
1. Prepare Battery
SEAT
ASSEMBL Y
k__.___l
BATTERY
CELL
FIGURE I
a.
b.
Fill and charge battery (before installing). NOTE:
SEE DETAILED INSTRUCTIONS PACKAGED
WITH BATTERY.
Remove and discard the tape seal covering bat-
tery tube. DO NOT REUSE.
SEAT SWITCH
.ADJUSTMENT
BOLTS
C,
d.
e,
f.
g.
h,
Fill each cell wffh battery acid. Add the acid un-
til it reaches the bottom of the battery tube (Fig,
1). Do not add the acid beyond this level or the
additional acid can come out when the battery
is charged.
After cells are filled, tilt battery from side to side
to release air bubbles.
Allow battery to stand and settle for at least thir-
ty minutes. If the level of acid falls below the
point described in step (c), add more acid until
the correct level is reached. NOTE: UNEVEN
FILLING OF CELLS WILL AFFECT THE BATTERY
CAPACITY AND LIFE. instafl the vent caps to
cover the battery tube. Wash the top of the bat-
tery with water to remove any acid, then wipe
dry.
Check battery case for leakage to make sure that
no damage has occurred in handling.
Neutralize excess battery acid for disposal by ad-
ding it to four inches of water in a five gallon
plastic container, Stir with a wooden or plastic
paddle while adding baking soda until the addi-
tion of more soda causes no more foaming.
Use a 12 volt battery charger. Charge battery at
a rate of 6 amperes for I hour. NOTE: OBSERVE
ALL SAFETY PRECAUTIONS REQUIRED FOR
BATTERY CHARGING. Check the acid level after
the battery is charged. If the acid has fallen
below the correct level, add only distilled water.
2.
7
\
FIGURE 2
Install Seat
a . Place seat on seat pan. Screw adjustment bolts,
Iockwashers and flat washers into seat (Fig. 2).
Adjustment bolts, Iockwashers and flat washers
found in bag of parts. Tighten finger tight.
b. Place seat in operating position. Sit on the seat
and press clutch-brake pedal all the way down.
If operating position is not comfortable, adjust
Seat.
c. Raise seat. Loosen adjustment bolts (Fig. 2).
When adjusted for comfortable operation,
tighten adjustment bolts securely with 9/16""
wrench.
Loading ...
Loading ...
Loading ...