Loading ...
Loading ...
Loading ...
— 11 —
Installation
STEP 6
Preparations
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
•Determine and mark the centre line on the ceiling or wall where the range hood will be installed.
•Make sure there is proper clearance within the ceiling or wall for exhaust vent.
•Due to the weight and size of this unit, please make sure that the support system or framework being used is stable and
secure in the ceiling or wall.
•Put a thick, protective covering over counter top, cooktop or range to protect from damage or dirt.
•Remove any hazardous objects around the area when installing.
CAUTION
If moving the cooking range is necessary to install the hood, turn OFF the power on an electric range at the main
electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.
STEP 7
Attaching Vent
Top venting using 6 in. (15.3 cm) round damper
•If you require 6 in. round venting, keep the unit as provided in the packaging and
install the round damper provided.
•Position the damper on top of the unit and set in place with screws provided (see
Figure 1).
•Connect duct work to damper.
•Use Duct Tape to ensure joint is sealed and air tight.
Top venting using rectangular damper
•If you require rectangular top (vertical) venting simply install the rectangular
damper provided (see Figure 2). Connect duct work to damper.
•Use Duct Tape to ensure joint is sealed and air tight.
Rear venting (horizontal) using rectangular damper
•Remove unit from packaging.
•Positiontheunitonitsbackonaatnon-abrasivesurface
- front facing you (see Figure 3).
•Remove the 2 lters to allow access to the inside of the
unit (see Figure 3).
•Cut tie wraps on motor cables so wires are free to move
and be relocated (see Figure 4).
Figure 1
Figure 2
Figure 3 Figure 4
Loading ...
Loading ...
Loading ...