Loading ...
Loading ...
Loading ...
44
REVISION HISTORY
REV
DESCRIPTION
DATE
APPROVED
TITLE
SIZE
Customer
DWG NO
REV
SCALE SHEET
Finish
N/A
B
ICM Cabinet to ICM-SB Cabinet
00
Engineering Release
01/01/2021
Todd Stone
37 Adams Blvd., Brantford, Ontario, N3S 7V8
P: (519) 751-1800 www.crownverity.com
1:7.5
2 of 2
00
IB-ICM-ICM-SB
Crown Verity
K Factor
Weight (Kg)
Gauge
N/A
N/A
N/A
DRAWN BY:
Todd Stone
Material
SS 304
01/01/2021
Dimensions are in inches
Linear Tolerance: +/- .015
Bend Tolerance: +/- .020
Angular Tolerance: +/- 0.5
Radial Tolerance: +/-.005
Copyright 2021 Crown Verity Inc. All rights reserved. Unauthorized duplication is a violation of applicable laws.
Align cabinet
flush along the
back seam.
Back panels
removed for clarity
In the assembly shown the base
cabinet (initial starting cabinet)
would be put in place and
levelled on all four legs prior to
attaching the next cabinet.
The attaching cabinet, would be populated with the
attachment brackets. The bottom attachment
bracket would rest on the edge of the base cabinet
for support while the hardware was installed. The
hardware would not be tightened until the attaching
cabinet is levelled and flush with the base cabinet.
The attachment brackets
provide structural support for the
side of the cabinet that is
attached. Legs are therefore
only required on the opposite
cabinet side.
D
E
Detail D
SCALE 1 : 1.88
With the side burner face
removed, the side burner is
attached to the adjacent
cabinet at this point with the
hardware provided.
7
1
3
23
4
19
Detail E
SCALE 1 : 1.88
The connector plate is attached to the
side burner at this location. There is a
corresponding mounting point on the
adjacent cabinet. Install the bracket but
do not tighten the hardware until the
cabinets have been aligned and levelled.
2
22
3
23
4
19
Side burner face and cabinet door
have been removed for clarity.
Loading ...
Loading ...
Loading ...