Loading ...
Loading ...
Loading ...
25
25
GAS OVEN INSTALLATION - Gas Connection
WARNING!
THIS OVEN MUST BE INSTALLED BY AN AUTHORISED PERSON –
PROOF IS REQUIRED FOR WARRANTY SERVICE CLAIMS.
The oven has been manufactured with a Natural Gas injector fitted. For
use with LPG the oven must be converted by an authorised technician.
The warranty will be voided if the LPG conversion is not undertaken by a
qualified gas fitter. The conversion kit is supplied. Information on
converting the oven is included with these instructions.
The requirements of the local gas and electrical authorities must be
adhered to, consult AS5601 as appropriate. Gas inlet fitting is 1/2” BSP
(male) thread. This oven can be connected with rigid pipe as specified in
AS5601 table 3.1.
This oven is approved for hose connection in compliance with AS5601,
clause 5.12.1.8. The flexible hose must comply with AS/NZS 1869 (AGA
Approved), 10mm ID, class B or D, between 1 – 1.2 m long and in
accordance with AS5601 for a high level connection. The hose should not
be subjected to abrasion, kinking or permanent deformation and should
be able to be inspected along its entire length. Unions’ compatible with
the hose fittings must be used and all connections tested for gas leaks.
THE HOSE MUST NOT BE EXPOSED TO TEMPERATURES EXCEEDING
THAT FOR WHICH IT IS CERTIFIED.
If the connection is for natural gas the test point pressure should be
adjusted to 1.00 kPa with the oven operating at maximum.
If installing for use with LPG ensure that an AGA approved gas regulator
suitable for a supply pressure of 2.75 kPa is part of the tank supply and
the test point pressure is adjusted to 2.75 kPa. There is a gas pressure
test point supplied with the oven that must be installed with the inlet hose.
It is recommended that an isolating valve and union be fitted, to enable
simple disconnection for servicing. These are to be in an accessible
location.
• Check connections are gas tight with soapy water or other
approved method.
• Under no circumstances use a naked flame in checking for leaks.
• Check Gas Adjustments (refer installation – gas checks and
adjustments).
Loading ...
Loading ...
Loading ...