CFG504WALP User Manual

Loading ...

operating for the ﬁrst time

Choosing utensils for gas and electric hotplates

Refer to diagram below

WARNING

Installation and service warning

• Onlyanauthorisedpersonmustinstallandservicethis

appliance (Certiﬁcate of Compliance to be retained)

• Inordertoavoidtippingofappliancetheanti-tiltplate

MUST be installed

• Appliancesrequiringconnectionto230–240VMUST

be earthed

• Anauthorisedpersonshouldinspectthisappliance

every 5 years

• ThisappliancemustNOTbeinstalledonabase,boxor

in a closed cupboard

• Iftheelectricalsupplycordisdamaged,aqualied

person MUST replace the cord to avoid a hazard or

void your warranty

•

WARNING

Surrounding kitchen cabinets MUST

WITHSTAND 85°C

• Inordertoavoidahazardtheinstallationinstructions

MUST be followed.

TIPS & INFORMATION

Before operating ﬁrst time

1. Read all the Warning and Safety information

2. Remove all internal boxes and bags from oven

3. Clean out the oven interior with detergent and hot water

and polish with a soft cloth. DO NOT close oven door

until the oven is completely dry

4. New appliances can have an odour during ﬁrst

operation. It is recommended to ‘run in’ the oven before

youcook.Runtheovenat180°Cfor2–4hoursand

ensure that the room is well ventilated

5. If your appliance is ﬁtted with solid hotplates, turn

heat setting to high for 3 minutes to fully harden the

hotplate coating.

GOOD BAD

(moisture on hotplate)

BAD

(convex base)

BAD

(oversize)

BAD

(recessed base)

BAD

(undersize)

BAD

(no utensil)