CFG504WALP User Manual

Loading ...

Electric wiring requirements

The cooker MUST be installed in compliance with

• WiringconnectionsinAS/NZS3000WiringRules

• Localregulations,municipalbuildingcodesandother

statutory regulations

• DataPlate–Givesinformationabouttheratingand

is located behind the bottom of the oven door

• Circuitdiagram–Islocatedonthebackpanelofthe

appliance

• AfunctionalswitchMUSTbeprovidedneartheappliancein

anaccessibleposition(AS/NZS3000–Clause4.7.1)

• WiringMUSTbeprotectedagainstmechanicalfailure(AS/

NZS3000–Clause3.9)

• Thecookerrequiresameansofallpoledisconnection

incorporated into the ﬁxed wiring. This MUST have a

disconnection gap of 3mm

• ThecookerMUSTbeproperlyearthed

• Whenconnectionsaremadetoamultiphase230/240V

supply, the bridge piece MUST be removed from between

the active connections

• If the supply cord is damaged, it must be replaced by

 themanufacturer,itsserviceagentorsimilarlyqualied 

persons in order to avoid a hazard.

Cable Tie

Plastic clip scre w

securing points

Gland

Plastic Clip

Hard wiring

1. Remove rear panel

2. Fit wires through hole at bottom centre using the appropriate

gland to protect insulation of wires from the hole edge. Note

that the secondary insulation of the wires will probably need

to be removed to ﬁt through gland. If the conduit to appliance

isrequiredtobendduetorearwallanelbowmaybe

requiredtoachievethis

3. Set the length of wiring from the gland to terminal block,

ensuring length is sufﬁcient but not excessive

4. Make connections to terminals and engage wires into plastic

clip. Cable tie as per diagram and secure plastic clip with

two long screws supplied

5. Replace rear cover.

WARNING

warning

Warning! Ensure wires cannot contact hot element ends

or sharp edges.

installation

20 INSTALLATION Chef 540 Upright Cooker

Loading ...

User Manual - Page 20