Loading ...
Loading ...
Loading ...
10
TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts.
Avoid contact with splashes of water.
To turn the appliance o, press the
button (g. 6).if fea-
tured, the appliance completes a rinse cycle and then goes o
(standby).
Please note!
If the appliance is not used for an extended period, also place
the main switch in the 0 position (g. 3).
Important!
To avoid damaging the appliance, do not place the main switch
(g. 3) in the 0 position until the appliance has been turned o
using the
button.
AUTO-OFF
The auto-o time can be changed so that the appliance switch-
es o after 15 or 30 minutes, or after 1, 2 or 3 hours.
The set the auto-o, proceed as follows:
1. With the machine o and the main switch in I position
(g. 3), press the
button and keep it pressed until the
lights on the control panel come on.
2. Press the button (on the left side of the dial) until
until the lights corresponding to the number of hours be-
fore the appliance goes o automatically come on:
15 minutes ECO
30 minutes ECO
1 hour ECO
2 hours ECO
3 hours ECO
3. Press the button (on the left side of the dial) to con-
rm; the lights switch o.
ENERGY SAVING
Use this function to enable or disable energy saving mode.
When enabled, the function reduces energy consumption in
compliance with European regulations.
Energy saving mode is active when the green ECO light is on (g.
7).
1. With the appliance o and the main switch in the I position
(g. 3), press the
button and hold it down until the
ECO light comes on (g. 7).
2. To disable the mode, press the button (on the left of
the dial). The ECO light ashes.
3. To re-enable the mode, press the ECO button (on the left of
the dial) again. The ECO light comes on steadily.
4. Press the button (on the right of the dial) to conrm
the selection. The ECO light goes o.
Please note :
A few seconds may elapse between energy saving mode and
delivery of the rst coee as the appliance must heat up again.
WATER SOFTENER FILTER (SOME MODELS ONLY)
Certain models are tted with a water softener lter. If this is not
the case with your model, you are recommended to purchase
one from De’Longhi Customer Services.
Important:
• Keep in a cool dry place out of direct sunlight.
• After opening the pac,, use the lter at once.
• Remove the lte before descaling the machine.
To use the lter correctly, follow the instructions below.
Installing the lter
1. Remove the lter from packaging and rinse the lter with
about half a litre of tap water (g. 8).
2. Rotate the calendar disk so that the next two months are
displayed (g. 9).
Please note:
The lter lasts about two months if the appliance is used nor-
mally. If the coee maker is left unused with the lter installed,
it will last a maximum of three weeks.
3. Remove the tank from the appliance and ll with water
(g. 1A).
4. Insert the lter in the water tank and immerse it complete-
ly, sloping it to enable the air bubbles to escape (g. 10).
5. Insert the lter in the lter housing and press as far as it
will go (g. 11).
6. Close the tank with the lid (g. 12), then replace the tank
in the machine.
7. Place a container (min. capacity: 100 ml) under the cap-
puccino maker.
8. Turn the steam dial in position I to deliver hot water.
9. Let the appliance to deliver hot water for a few seconds, til
the delivery ows regulary, then turn the dial in position 0.
Please note:
It may happen that a single hot water is not sucient to install
the lter: the lghts
come on.
In this case, repeat the installing operation from step 8.
The new lter is active and you can now use the coee maker.
Loading ...
Loading ...
Loading ...