Loading ...
Loading ...
Loading ...
GB
- 44 -
Troubleshooting
Fault Possible cause Remedy
The robot lawn mo-
wer comes to a stop
in the mowing area.
The robot lawn
mower cannot be
switched on:
- Battery voltage too low
- Fault in the power circuit or
the electronic components
- Bring the robot lawn mower back to the
charging station (19) for charging.
- Switch on the main switch (7) (ON).
- Contact your customer service center.
The robot lawn
mower cannot move
into the charging
station.
- The charging station (19) is
not installed correctly.
- Make sure that the LED indicator (21) on
the charging station (19) is lit up green.
- Make sure that the perimeter wires (18)
on the underside and front of the char-
ging station (19) are connected and that
the front perimeter wire (18) is laid in the
middle underneath the charging station
(19).
- Make sure that the charging station (19) is
positioned correctly.
The robot lawn mo-
wer shows irregular
behavior around
perimeter islands
- The perimeter wire (18) has
not been installed correctly
around the perimeter islands.
- Adjust the position of the perimeter wire
(18).
- Take care to ensure that the perimeter
wire (18) is not crossed over and is laid
clockwise around the perimeter islands.
The robot lawn mo-
wer is very loud.
- Damaged blades (10)
- A large amount of foreign
bodies adhere to the blades
(10)
- The robot lawn mower has
started too close to obstac-
les
- Damaged blade drive or
drive motor
- Other parts of the robot lawn
mower are damaged
- - Replace the blades (10). The 3 blades
(10) must all be replaced together at the
same time.
- The operating effi ciency of the robot lawn
mower is dependent on the sharpness of
the blades (10). You should therefore en-
sure that the blades (10) are maintained in
good condition.
- Switch off the robot lawn mower safely
and wear work gloves while you clean the
blades (10) in order to avoid getting cut.
- Arrange for the motor to be repaired or
replaced by your customer service center.
The robot lawn
mower stays in the
charging station.
The robot lawn mo-
wer keeps returning
to the charging
station
- Incorrect work time settings
- The rechargeable battery
(22) is empty
- Check the work time settings.
- The robot lawn mower begins its work at
the same time each day and works within
the set time window. Outside this time
window the robot lawn mower stays in the
charging station (19).
IMPORTANT! Severed perimeter wires and consequential damages are not covered by the war-
ranty!
Anl_FREELEXO_BT_SPK9.indb 44Anl_FREELEXO_BT_SPK9.indb 44 12.10.2020 16:55:0712.10.2020 16:55:07
Loading ...
Loading ...
Loading ...