Loading ...
Loading ...
Loading ...
GB
- 41 -
11. Indicators on the charging station and troubleshooting
LED indicator (21) Description Solution
Off - No power supply - Check the power supply
Lit up green - Ready for mowing
- Rechargeable battery (22) is
fully charged
- Perimeter wire (18) is cor-
rectly installed
Flashing green - Perimeter wire (18) is se-
vered
- Perimeter wire (18) is not
properly connected
- Inspect the perimeter wire (18) for a break
- Check the two connections on the char-
ging station (19)
Lit up red - Rechargeable battery (22) is
charging
- Wait until the rechargeable battery (22) is
fully charged.
12. Indicators on the robot lawn mower and troubleshooting
The alarm LED (53) is lit up red
Fault Possible cause Remedy
“Robot lawn mower
has lifted”.
- The lifting sensor has been
continually tripped for 10 se-
conds
Press the “OK” button (61) to restart the ro-
bot lawn mower.
- If this fault occurs frequently, check the
mowing area for obstacles taller than 10
cm and either remove them or cordon
them off from the mowing area with peri-
meter wire (18).
“Robot lawn mower
is stuck”
The robot lawn
mower has come
to a stop near an
obstacle.
- The obstruction sensor has
tripped 10 times within one
minute
Press the “OK” button (61) to restart the ro-
bot lawn mower.
- Check whether the robot lawn mower
is blocked by an obstacle or jammed
between trees, bushes, etc. Remove the
obstacle or avoid this area.
- If this fault occurs frequently, check the
way in which the perimeter wire (18) has
been laid. Pay particular attention to tight
angles, corridors, fences, rocks, etc., and
adjust the layout of the perimeter wire (18)
if necessary.
- Check whether the grass is too tall and
the robot lawn mower gets blocked. If this
is the case, mow the grass to below 60
mm.
Anl_FREELEXO_BT_SPK9.indb 41Anl_FREELEXO_BT_SPK9.indb 41 12.10.2020 16:55:0612.10.2020 16:55:06
Loading ...
Loading ...
Loading ...