Waldorf RNLB8900G-LS Installation Operation Manual

Loading ...

Specifications

- All Other Markets

NOTE:

 (*) Measure Burner operating pressure at manifold test point with two burners operating at

'High Flame' setting.

 NAT, LPG & Butane Only - Operating pressure is ex-factory set and is not to be adjusted,

unless when converting between gases, if required.

 (**) TOWN GAS Only - Adjust burner operating pressure using adjustable gas regulator

supplied.

 Refer to ‘Gas Conversion and Specifications' section in this manual for further details.

Gas Connection

Gas supply connection point is located at rear of appliance, approximately 130mm from right hand

side, 32mm from rear and 655mm from floor (55mm from floor for bench top – B models) and is

reached from beneath appliance. (Refer to ‘Dimensions’ section).

Connection is ¾" BSP male thread (for all other models).

Natural Gas Town Gas (**)

Input Rate (N.H.G.C.)

- each Open Burner

28 MJ/hr

Supply Pressure

1.13 - 3.40 kPa 0.75 - 1.50 kPa

Burner Operating Pressure (*)

0.95 kPa 0.63 kPa

Gas Connection See ‘Gas Connection’ information below.

LP Gas / Butane