Loading ...
Loading ...
Loading ...
ENGLISH
Installation
1
Check that:
- the electrical installation has sufficient
voltage (220-240 Volts~ 16 Amps).
If the electrical installation in your home
requires any changes in order to connect your
appliance, contact a professional electrician.
During maintenance operations, the
appliance must be unplugged from the
electrical grid; fuses must be switched off or
removed.
Warning:
The safety wire (green-yellow) is
connected to the appliance’s
terminal and must be connected to the
installation’s earth.
If the oven malfunctions in any way,
unplug it or remove the fuse for the
circuit where the oven is installed.
Warning:
We cannot accept liability for any
accident or incident resulting from
non-existent, defective or incorrect
grounding.
CHOICE OF LOCATION AND BUILDING IN
This appliance must be installed more than
850 mm up off the ground. This appliance may be
installed in a cabinet column, as indicated on the
installation diagram (fig. A).
Caution: if the back of the cabinet is open, the
space between the wall and the surface on which
the oven rests must be no more than 70 mm*
(fig. B).
Do not use your appliance immediately (wait for
about 1 to 2 hours) after transferring it from a cold
place to a warm place, as condensation may cause
a malfunction.
Centre the oven in the cabinet so as to ensure a
minimum distance of 10 mm between the
appliance and the surrounding unit. The material
of the cabinet supporting the appliance must be
heat resistant (or covered with a heat-resistant
material).
Drill a 2 mm diameter hole in the cabinet panel to
avoid splitting the wood.
For greater stability, attach the oven to the unit
with 2 screws through the holes provided on the
side panels (fig. C).
ELECTRICAL CONNECTION
Warning:
Installation should only be performed by
qualified installers and technicians.
The appliance must be recess-fitted correctly to
ensure electrical safety. The electrical connections
should be made before the appliance is installed in
its housing.
The oven must be connected via a standardised
power cable with 3 conductors of 1 mm² (1 live +
1 neutral + earth) which must be connected to the
network by means of an IEC 60083 standard power
socket or via an all-pole cut-off device in compliance
with the installation rules.
Loading ...
Loading ...
Loading ...