Sun Joe BDL-A0215 DIY Workshop Bundle Cordless 24-Volt Metal/Wood Cutter + Drill

OPERATOR’S MANUAL - CORDLESS HANDHELD RECIPROCATING SAW - Page 11

For BDL-A0215. Also, The document are for others Sun Joe models: 24V-MPSWVG-LTE-SJG

PDF File Manual, 56 pages, Read Online | Download pdf file

BDL-A0215 photo
Loading ...
Loading ...
Loading ...
11
IMPORTANT! The product is intended for purposes listed
below:
Cutting all types of wood products (lumber, plywood,
panelling composition board, and hard wood).
Cutting masonite and plastic.
Cutting drywall.
Cutting metals such as sheet steel, pipe, aluminum, brass,
and copper.
Any other use diering from the above mentioned applications
poses a serious hazard to the user and may damage both
the tool and your personal property. Improper use of the tool
will invalidate the warranty, relieve the manufacturer from all
liabilities. The user will consequently be liable for all and any
damage or injury to himself/herself or others.
Selecting Blades
Selecting the correct blade type is important in order to obtain
the best performance of the saw. Select the blade based on
the application and on the material you wish to cut. Selecting
the right blade will give you a smoother, faster cut and prolong
the life of the blade.
Blades with fewer teeth are typically used for cutting wood,
while blades with more teeth are better for cutting metal or
plastic. We recommend 14 TPI for plastics and soft metals and
18 TPI for hard metals. Check the table below for details about
the included blades.
Starting and Stopping
1. Ensure the blade and the branch jaw clamp (if used)
are securely assembled. Insert the battery in the battery
compartment (Fig. 7).
2. To start the tool, rst press and hold the safety lock
button, then squeeze the On/O trigger (Fig. 8). When the
machine is running, release the safety lock button.
NOTE: The safety lock button, located on the handle
above the On/O trigger, reduces the possibility of
accidental starting.
3. To turn o the tool, release the On/O switch.
Using the Branch Jaw Clamp
The branch jaw clamp will grip the workpiece, providing cutting
of unsupported workpiece. When cutting wider branches
or timber, the branch jaw clamp can be removed to obtain
a deeper cutting capacity. In this case, use a clamp/vise to
secure the workpiece in place.
NOTE: When the branch jaw clamp is attached, the cutting
capacity with wood blade will be reduced to 1.65 inch (42 mm).
The cutting capacity with metal blade will not be aected by
the branch jaw clamp.
7 TPI
Teeth
Size
Recommended
application
Wood Cutting
Blade (x2)
Metal Cutting
Blade (x2)
26 TPI
Length:
6 in. (152.5 mm)
Width:
0.77 in. (19.5 mm)
Thickness:
0.05 in. (1.2 mm)
Length:
4 in. (101.5 mm)
Width:
0.75 in. (19 mm)
Thickness:
0.035 in. (0.9 mm)
Contour cutting
in all woods,
and composition
materials.
All metals less
than 1/8". Tubing,
conduit and trim.
R
Battery pack
Fig. 7
R
On/O switch
Fig. 8
Safety lock button
Loading ...
Loading ...
Loading ...