Loading ...
Loading ...
Loading ...
en
26
Remote Options **
The dishwasher installs itself automatically
during the first use within a serve@Home
network. In some cases however, it might
become necessary to start the enrolment
process anew.
If the option “Remote Options” is
selected, the message “Enrol Device”
will be displayed. By pressing the
button +
3 you enrol the device
again at the gateway. After successfully
enrolling the device the message
“Auto Wash” will be displayed.
If the enrolment is unsuccessful the
display shows “no gateway found”.
** Only with installed interface
Aqua sensor
The Aqua sensor is an optical measuring
device which measures the turbidity of the
rinsing water. A light barrier can detect
dissolved food remnants in the water, e.g.
egg, fat and oats.
The Aqua sensor is used according to
the programme. When the Aqua sensor
is active, ”clean” rinsing water may be
transferred into the next rinsing bath
and/or the temperature adjusted. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In this
way the water consumption is reduced by
approx. 4 litres for utensils which are ”less”
dirty.
Start programme
Before starting check again whether the
spray arms can move freely.
Press the button “Start” 4 in the Main
Menu.
The message “Close the door” will be
displayed, alternating with a display of
the expected programme time. This time
is only approximate. The running time
indicated at the start of the set programme
will probably be required. During the
programme run the remaining time will be
adjusted according to the water supply
temperature and the amount and soil level
of the dishes.
If you have chosen a time for the
programme start the message “Close the
door” will appear when the programme is
started, alternating with the pre-selected
time.
Close the door.
The programme or the pre-selected time
respectively will run.
The programme and other settings can still
be changed as long as the door is still
open after pressing the button “Start”
4 .
By pressing the button M/OK
2
“Return”, return to the Main Menu where
you can change the settings. Finally start
the programme again.
When the door is closed after the start and
the programme has already started, you
will have to interrupt the programme in
order to change any settings (see “Cancel
Programme”).
Loading ...
Loading ...
Loading ...