Loading ...
Loading ...
Loading ...
I II III I
i i I i I IJ i I ill IIIIIIIIIIIIIIIIIII
TROUBLE SHOOTING C ART ....
IIII l ill ii II i l ii il i illi Illil i i illlii II i lii ilili iiiiiiIIIIIIIIIIIIIIIIIIII I ii
CAUSE REMEDY
, m, .m, ,,1 J.,.
SYMFrOM
, m ,
Blade stops under a
load or does not
turn when switch
is pressed.
Blade turns but
will not cut.
Edger drags ground
or cuts too deep.
a. Forcing blade into material being c_t.
b. Depth adjustment set too low.
e. Blade guard clogged with debris.
d. Edge guide bent toward blade.
e. Unit unplugged.
f. None of the above.
,,Jmnlm 11 ,
a. Incorrect Blade_lade worn too short.
b, Depth Adjustment set too high.
c. Neither of the above.
,,m
a. Edger depth adjustment set too low,
b. Depth adjustment mechanism(s) or
wheel mount(s) broken.
c. Neither of the above.
Cut at a slower pace.
b. Raise edger by altering depth adjustment.
c. Clean blade guard area.
d. Replace edge guide.
e. Plug unit into astandard 120 volt outlet.
f. Contact your SEARS Service Center!Dept.
m , , ,
a. Replace blade.
b. Lower edger by altering depth adjustment.
c. Contact your SEARS Service Center!Dept.
,,,,U,,LV,,,,,,...................................,11,,,1, 11 , ,1, ,
a. Raise edger by altering depth adjustment.
b. Contact your SEARS Service Center/Dept.
c. Contact your SEARS Service Center/Dept.
I I
I II I I
SAFETY GOGGLES
BLADE
EXTENSION COP_
I IIIIIII III I I I
NOTES
- 10 -
Loading ...
Loading ...