Loading ...
Loading ...
Loading ...
Solutions to Common Problems
OCCURRENCE
Range is not level
POSSIBLE CAUSE/SOLUTmON
Poor installation. Place oven rack in center of oven. Place a level on the oven rack.
Adjust leveling legs at base of range until the rack is Ievel. When range is level,
cooktop may appear out of alignment if countertop is not bvek
Weak, unstable floor. Be sure floor is level and can adequately support range. If floor
is sagging or slopping, contact a carpenter to correct the situation.
Kitchen cabinet misalignment may make range appear to be unleveL Be sure
cabinets are square and have sufficient room for range clearance.
Cannot move appmiance easily,
Appliance must be acceseibme for
service.
Cabinets not square or are built in too tight. Contact a cabinet maker to correct the
problem.
Contact builder or installer to make appliance accessible.
Carpet interferes with range. Provide sufficient space so range can be lifted over
carpet.
Gas Iine is hard@lumbed. Have a flexible C.S.A international approved metal
appliance connector installed.
Entire range or oven does not operate. Make sure cord/plug is plugged tightly into outlet.
Service wiring is not complete. Call an authorized servicer.
Electrical power outage. Check house lights to be sure. CalI your local electric
company for service. Surface burners can be lit manually.
*Oven control beeps and displays any F Electronic control has detected a fault condition. Press STOP/CLEAR to clear the
code error (for exampme Fll) display and stop beeping. Reprogram oven. If fault recurs, record fault number. Press
STOP/CLEAR and call an authorized servicer for assistance.
Oven light does not work,
Replace or tighten bulb. See Changing Oven Light section in this Use & Care Guide.
Electrical power outage. Check house lights to be sure. CalI your local electric
company for service.
Surface burners do not might,
Surface control knob has not been compietely turned to LITE. Push in and turn the
surface control knob to LITE until burner ignites and then turn the surface control
knob to the desired flame size.
Burner ports are clogged. Clean burners. See "Cleaning the Burner Grates, Burner
Caps and Burner Heads" under General Cleaning.
Range power is disconnected from outlet. Be sure cord is securely plugged into the
outlet.
Electrical power outage.
Surface burner flame burns haft way
around,
Be sure the gas supply to the range is turned "ON".
Burner ports or slots are clogged. With the burner off, use a smalPgauge wire or
needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow the burner to
operate until flame is full. Dry the burners thoroughly following instructions under
General Cleaning.
21
Loading ...
Loading ...
Loading ...