Loading ...
Loading ...
Loading ...
29
31
https://www.altonindustries.com
info@altonindustries.com
2
The sharpening angle of 30° must be the same on all cutters. Different
cutter angles cause the chain to run roughly and unevenly, accelerate
wear, and lead to chain breaks.
The angle of the saw chain teeth is 55°. Use a suitable round file so that
the proper sharpening angle is kept against the teeth.
The diameter of the round file which fits for the saw chain is 4mm.
The file should only engage the cutter on the forward stroke. Lift the file
off the cutter on the return stroke.
Sharpen the shortest cutter first. Then the length of this shortest cutter
becomes the standard for all other cutters on the saw chain.
Remove any projecting material, however small, with a special flat file.
Round off the front of the depth gauge again.
CLEANING THE GUIDE BAR
Chips and sawdust will build up in the guide bar groove. They may clog the
bar groove and impair the oil flow. Clean out the chips and sawdust every
time when you sharpen or replace the saw chain.
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a
problem that is not explained in the manual, do not attempt to dismantle
the tool.Instead, ask ECOMAX Service Centers, always using ECOMAX
replacement parts for repairs.
1
2
STORING THETOOL
Guide bar groove Guide bar
1
Clean the tool before storing. Remove any chips and sawdust from the
tool after removing the chain cover.
2
After cleaning the tool, run it under no load to lubricate the saw chain
and guide bar.
3
Cover the guide bar with the guide bar cover.
4
Empty the oiltank.
1
PROBLEM
POSSIBLE CAUSE
SOLUTION
The guide bar
and the
chainbecome
hot and
release smoke.
The chain is too tight.
Adjust the chain tension.
The oil tank is empty.
Add lubricants.
Contaminationcausesablockageof
the discharge port.
Removethe guide bar and clean the
dischargeport.
Contaminationcausesa blockage
of the oil tank.
Clean the oil tank.Add new lubricant.
Contaminationcausesa blockageof
the guide bar and the oil tank cap.
Clean the guide bar and the oil
tank cap.
Contaminationcausesa blockageof
the sprocket or guide wheels.
Clean the sprocketand the guide
wheels.
The guidebar
and the
chainbecome
hot and
release smoke.
The chain is too tight.
Adjust the chain tension.
The guide bar and the chain are
damaged.
Replacethe guide bar and the
chainif it is necessary.
The motor is damaged.
1.
Removethe battery packfrom the
machine.
2.
Removetheguidebarcover.
3.
Removethe bar and sawchain.
4.Clean the machine.
5.Installbatterypack and operatet
he machine.
lfthesprocketrotates,itmeans the
motor works properly.If not, call
servicecenter.
The motor runs
and the chain
rotates,but the
chain does not
cut.
The chain is blunt.
Sharpen or replace the saw chain.
Thechainisintheincorrectdirection.
Turnthe chain loop to the other
direction.
The chain is tight or loose.
Adjust the chain tension.
Loading ...