Loading ...
Loading ...
Loading ...
19
20
https://www.altonindustries.com
info@altonindustries.com
2
3
2
3
CHECKING THE CHAIN BRAKE
CAUTION! Hold the chain saw with both hands when switching it on.
Hold the top handle with your right hand, the front handle with your left.
The bar and the chain must not be in contact with any object.
CAUTION! Should the saw chain not stop immediately when this test is
performed, the saw may not be used under any circumstances. Consult
our service center.
1
Push the lock-off lever to the left, then pull the switch trigger. The saw
chain starts immediately.
2
Push the front hand guard forwards with the back of your hand. Make
sure that the chain saw comes to an immediate standstil.
ASSEMBLY
CAUTION! Always be sure that the tool is switched off and the battery
pack is removed before adjusting or checking function on the tool.
CAUTION! Do not touch the saw chain with bare hands. Always wear
gloves when handling the saw chain.
REMOVING OR INSTALLING SAW CHAIN
CAUTION! The saw chain and the guide bar are still hot just after the
operation. Let them cool down enough before carrying out any work on
the tool.
CAUTION! Carry out the procedure of installing or removing saw chain
in a clean place free from sawdust and the like.
To remove the saw chain, perform the following steps:
1
Release the chain brake by pulling the front hand guard
2
Loosen the guide bar plate compression twist, then the chain tension
regulator.
Front hand quard Locked position Unlocked position
CHECKING THE CHAIN BRAKE
CAUTION! If the saw chain does not stop within two seconds in this test,
stop using the chain saw and consult our authorized service center.
Run the chain saw then release the switch trigger completely. The saw chain
must come to a standstill within two seconds.
ELECTRONIC FUNCTION
The tool is equipped with the electronic functions for easy operation.
Soft start
The soft-start function minimizes start-up shock, and makes the tool start
smoothly.
Chain cover Guide bar plate compression twist Chain tensioning regulator
3
Remove the chain cover then remove the saw chain and guide bar from
the chain sawbody.
2
3
1
1
2
3
1
1
Loading ...
Loading ...
Loading ...