Loading ...
Loading ...
Loading ...
ninjakitchen.com
ninjakitchen.com
P
A
D
D
L
E
R
E
L
E
A
S
E
NOTES:
• TOP and BOTTOM modes are not available with DRINKABLE programs.
• If the install light is illuminated, the unit is not fully assembled for use. If the light is blinking, ensure
the bowl is properly installed. If the light is solid, check that the paddle is installed. Ensure to plug
the unit in before installing the bowl.
6 Position the tab of the lid just slightly to the right of the outer bowl handle
so the lines on the lid and handle align. Rotate the lid clockwise to lock.
7 With the unit plugged in, place the outer bowl onto the motor base with
the handle centered below the control panel. Twist the handle to the right
to raise the platform and lock the bowl in place, signaled by a click.
5 Press and hold the paddle latch on the top of the outer bowl lid, then insert
the Deluxe Creamerizer™ Paddle in the bottom of the lid. Release the latch
to secure the paddle. When fully installed, the latch will be centered and the
paddle will be slightly loose. Press the power button to turn on the unit.
USING THE CREAMi® – CONT
9 When program is complete, remove the outer bowl by holding the bowl
release button on the left side of the motor base and twisting the handle
back to the center. As the handle is twisted, the platform will lower the
bowl. Pull the bowl straight back towards to you to remove.
11a If adding mix-ins, use a spoon to create a 1
1
/2-inch wide hole that reaches
the bottom of the processed portion of the Deluxe Pint. Add chopped
or broken mix-ins to the hole in the Deluxe Pint and repeat steps 6–10 to
process again using the same processing zone and the MIX-IN program.
11b If not adding mix-ins, RE-SPIN can be used on a crumbly or powdery Deluxe
Pint to make it more creamy. RE-SPIN is often needed for very cold bases.
If the treat is smooth and scoopable, go to step 12. If the base is crumbly or
powdery, repeat steps 6–10 to process again using the RE-SPIN program.
NOTE: Do not RE-SPIN before using the MIX-IN program.
NOTE: The unit does not allow One-Touch Programs to be run back to back. Between programs,
lower the bowl and check the results before proceeding.
12 Lift the Deluxe Pint out of the outer bowl and enjoy!
NOTE: If your treat contains mix-ins, processing again will further crush your mix-ins and create a
new flavor.
MIX-IN TIPS
Add
1
/4 cup of crushed candies, frozen fruits, chopped nuts, chocolate pieces, and more. When
adding several dierent types of mix-ins, do not exceed
1
/4 cup in total. Adjust the quantity of
mix-ins to taste, ensuring the outer bowl lid can still comfortably close over the Deluxe Pint.
Hard mix-ins will remain intact.
Mix-ins like chocolate, candy, and nuts will not be broken down during the MIX-IN program. Use mini
chocolate chips and candies or pre-chopped ingredients.
Soft mix-ins will get broken down. Mix-ins like cereal, cookies, and frozen fruit will end up smaller
after the MIX-IN program. Use bigger pieces of soft ingredients.
For ice cream and gelato, fresh fruit, sauces, and spreads are NOT recommended as mix-ins. Adding
fresh fruit, fudge, and caramel sauces will water down your treat. Chocolate hazelnut spread and nut
butters also do not mix well. Frozen fruit or chocolate/caramel shell toppings are recommended.
IMPORTANT: Review all warnings before proceeding.
8 Press the power button to turn on the unit. If the outer bowl is properly
installed, the control panel will illuminate and the unit will be ready for use.
Press TOP, FULL, or BOTTOM, then use the dial to select the program that
matches your base. The program will automatically stop when complete.
10 To remove lid, press the lid unlock button and twist the lid counterclockwise.
13 Rinse the outer bowl lid to remove any sticky residue or pieces wedged in the
Deluxe Creamerizer™ Paddle. Then detach the paddle by pressing the latch on the
top of the outer bowl lid. For easy cleanup, release paddle directly into the sink.
14 Turn the unit o by pressing the power button. Unplug the unit when finished.
Refer to the Care & Maintenance section for cleaning and storage instructions.
15 Didn’t finish your Deluxe Pint? Flatten the top of your frozen treat with a
spoon or spatula before refreezing. If the treat is hard after re-freezing,
process it again on the program used to make it. If it’s soft, just scoop and
enjoy it. Before re-processing a drinkable leftover, add a 4 oz. pour-in of
your choosing for FROZEN DRINK or a 6 oz. pour-in of your choosing for
SLUSHI or CREAMICCINO.
Loading ...
Loading ...
Loading ...