Loading ...
Loading ...
Loading ...
BEPORE USING WATER FROM YOUR WATER PURIFIER FOR THE FIRST TIME
continued from page 4
12. Stearowillcontinuetopassthroughforafewmin- water which may have some harmless carbon
utes. After unit cools, rinse out kettle, tines (very fine black particles) init fromthefilter.
13. Shake the carafe, then discard the first batch of
MAKING PURIFIED WATER
1. Set the Purifier on your countertop or table. 6. Plug the power cord into any 120 volt outlet.
2. Unplug the kettle from the base (Figure 1). Twist
the cover counter-clockwise to remove, and set
aside.
3. Rinse and fill the ketfie with tap water up to the
max. fill line.
NOTE: You can pudfy less than the full amount. Use
this chart as a guide. DO NOT fill the kettle over the
max. fill line because the carafe will overflow.
WHEN YOU FILLWlTH THE CYCLE TAKES
TAP WATER TO...
Model 344800 (3 qt.) 5 hours
Modet 3448"t0 (1 gallon) 4 hours
4. Replace the cover on the kettle. Twist cover
clockwise to lock. Plug the kettle into the base
unit. Carry carefully and keep level to prevent
splashing.
7. Press the reset or start button. The red indicator
light will illuminate.
WhenthecyclaisoverthePurifiertumsoffautoroa_cal-
ly. AFTER THE FAN MOTOR GOES OFF, WAIT AT
LEAST 30 MINUTES BEFORE REMOVING THE
COVER...
WARNING: NEVER REMOVE THE COVER WHILE
THE FAN MOTOR IS RUNNING, OR FOR 30 MIN-
UTES AFTER IT STOPS. YOU COULD GET SE-
VERE BURNS FROM THE BOILING WATER OR
STEAM.
B. To pour water from carafe, open spout by pulling
on center stdp in direction of the arrow indicator
near thumb position.
9. Store the carafe filled withproductwatar inthe re-
frigerator until you need it.
5, Set the carafe into placeonbase unit,
CARE AND CLEANING OF YOUR WATER PURIFIER
10. After the Purifier has ccoled (wait for 30 roinutes
after the fan motor stops running) remove the
kettle to clean.
KEI-rLE
After each use, dnse theinside with lukewarm tap water
and remove any residue. Clean by wipingout the inside
of the kettle with a damp cloth and rinse. If a deposit
starts to form at the bottom, use Kenroore Water Pudfier
cleaner (see page 7). ReSidue build up on the bottom
of the kettle will prevent the system from purifying
a complete batch of water. Remove the kettle from
base unit. Fill kettle at the sink wfth hot water and follow
the instructions on the cleaner boffie. Rub with a soft
scouring pad and rinse thoroughly.
CAUTION: DO NOT IMMERSE THE PURIFIER OR
KETTLE IN WATER.
CARAFE
Clean with mild dish detergent and softcloth. Rinse
thoroughly with water.
CLEANING EXTERIOR SURFACES
TOkeep your Purifier looking new, you shouldpaded-
icafly clean the exterior plastic surfaces witha soft,
damp cloth. DO NOT use any caustic cleaning solu-
tions, scoudng pads or powder because they will
damage the plastic finish.
NOTICE J
THERE ARE NO USER SERVICEABLE PARTS
INSIDE THE UNIT.
CHANGING THE CARBON RLTER
IMPORTANT: The purifieruses a carbon filterinthe ca-
rafecover to remove traces of odors before the purified
water iscollected in the carafe. The filterslast about2-3
months. A retum of unwanted odor means the tilter
should be replaced. Order replacement carbon filters
from Sears (see page 7).
continued, page 6.
5
Loading ...
Loading ...