Loading ...
Loading ...
Loading ...
1 Clamp screw
3. Loosen the wing nut on the straight guide and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing nut.
1
1 Wing nut
4. Move the tool with the straight guide flush with the side
of the workpiece.
If the distance (A) between the side of the workpiece and
the cutting position is too wide for the straight guide, or if
the side of the workpiece is not straight, the straight guide
cannot be used.
In this case, firmly clamp a straight board to the
workpiece and use it as a guide against the router base.
Feed the tool in the direction of the arrow.
A
11.7 USE THE STRAIGHT GUIDE FOR
CIRCULAR WORK
For circular work, assemble the straight guide as shown in the
figures. The minimum and maximum radius of circles to be
cut (distance between the center of circle and the center of
bit) are as follows:
• Minimum: 2-3/4" (70 mm)
• Maximum: 8-11/16" (221 mm)
For cutting circles between 2-3/4" (70 mm)and 4-3/4" (121
mm) in radius.
1
1 Center hole
For cutting circles between 4-3/4" (121 mm) and 221 mm
8-11/16" (221 mm) in radius.
1
1 Center hole
NOTE
Circles between 6-3/4" (172 mm) and 7-5/16" (186 mm) in
radius cannot be cut using this guide.
1. Align the center hole in the straight guide with the center
of the circle to be cut.
2. Drive a nail less than 1/4" (6 mm) in diameter into the
center hole to secure the straight guide.
3. Pivot the tool around the nail in the clockwise direction.
2
1
1 Nail 2 Center hole
12
English (Original Instructions)
EN
Loading ...
Loading ...
Loading ...