Loading ...
Loading ...
Loading ...
NOTE
If the tool is not secured after closing the lock lever, tighten
the hex nut, and then close the lock lever.
1
1 Hex nut
11.5 USE THE TOOL WITH THE
ROUTER BASE
1. Set the tool base on the workpiece without the router bit
making any contact.
2. Turn the tool on and wait until the bit attains full speed.
3. Move the tool forward over the workpiece surface. Keep
the tool base flush while moving the tool.
4. When cutting the edge, be sure to keep the workpiece
surface on the left side of the router bit in the feed
direction.
NOTE
Before cutting on the actual workpiece, it is
recommended to make a sample cut. The proper feed
speed depends on the bit size, the kind of workpiece,
and depth of cut. Moving the tool forward too fast may
cause a poor quality of cut, or damage to the bit or
motor. Moving the tool forward too slowly may burn
and mar the cut.
When using the router shoe, the straight guide, or the
router guide, be sure to keep it on the right side in the
feed direction. This will help to keep it flush with the side
of the workpiece.
1
3
2
1 Router bit 2 Workpiece
3 Straight guide
NOTICE
Since excessive cutting may cause overload of the
motor or difficulty in controlling the tool, the depth of
cut should not be more than 1/8" (3 mm) at a pass when
cutting grooves. When you wish to cut grooves more
than 1/8" (3 mm) deep, make several passes with
progressively deeper bit settings.
11.6 USE THE STRAIGHT GUIDE
Optional accessory
1. Assemble the straight guide with the bolt and the wing
nut.
2
1
1 Bolt 2 Wing nut
2. Attach the straight guide to the router base with the clamp
screw.
1
11
English (Original Instructions)
EN
Loading ...
Loading ...
Loading ...