ASSEMBLY
1. Localisez un poteau mural avec un détecteur de poteaux
pour monter le chargeur, où, une fois monté, il peut être
branché dans une prise facilement accessible mais hors
de la portée des enfants.
2. Utilisez uniquement le cordon d’alimentation fourni avec
le kit et enroulez l’excès de longueur de cordon autour de
l’enrouleur de cordon situé à l’arrière du chargeur.
3. Retirez la plaque indicatrice de charge, comme illustré à
du goujon.
4. Tenez le chargeur au mur, montez et serrez la vis
supérieure, puis la vis inférieure (2).
5. Replacez la plaque indicatrice de charge réversible sur le chargeur.
7. Rangez les batteries en les faisant glisser dans le chargeur et en les poussant vers le bas pour les sécuriser. IMPORT
-
ANT: Assurez-vous toujours que les piles sont bien en place. Tenez fermement la batterie pour vous assurer qu’elle ne
tombe pas. La chute peut causer des dommages ou des blessures.
AVERTISSEMENT :
Pour éviter tout risque
d’étranglement, d’incendie ou de choc électrique, acheminez le
cordon correctement, en évitant les boucles, hors de la portée
des enfants et où ils ne puissent se faire accrocher ou tirer.
AVERTISSEMENT :
Si vous touchez du
métal, arrêtez immédiatement et contactez un électricien.
UTILISATION
UTILISATIONS
• Charger les piles au lithium-ion ONEPWR
MC
.
• Effectuez une charge complète de la pile avant la première utilisation. La durée
pile n’est pas complètement chargée au moment de l’achat.
• Assurez-vous que l’alimentation électrique a une tension résidentielle normale
• Ne placez pas le chargeur dans une zone de chaleur ou de froid extrêmes. Il
fonctionnera mieux à la température ambiante.
• Branchez le chargeur dans une prise électrique.
• Fixez le bloc-piles au chargeur en alignant les rainures en saillie sur le bloc-
piles avec les rainures du chargeur. Faites glisser le bloc-piles dans le chargeur.
• Le bloc-piles deviendra légèrement chaud au toucher pendant la charge. Cette chaleur est normale et n’indique pas de problème.
• Pendant la charge, les voyants de la pile s’allument pour indiquer l’état de la charge. Le voyant du chargeur clignote.
• Si le voyant du chargeur clignote en rouge, une erreur s’est produite avec la pile ou le chargeur. Réessayez ou communiquez avec
le service à la clientèle pour obtenir de l’aide.
• Lorsque la charge est terminée, les voyants de la pile et le chargeur s’éteignent.
READ ALL INSTRUCTIONS BEFORE USING THIS CHARGER
• Dry location use only.
• For use only with ONEPWR™ Batteries. Charge only battery packs listed in Compatible Battery Packs Section of this
• Do not use with damaged cord or plug. If charger is not working as it should, has been dropped, damaged, left outdoors,
or dropped into water, call Customer Service at 1-800-406-2005.
• Do not pull or carry by cord, use cord as a handle, or pull cord around sharp edges or corners. Keep cord away from
heated surfaces.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Do not handle plug or charger with wet hands.
•
• Do not disassemble charger. Do not modify or attempt to repair the charger. This charger has no serviceable parts. Call
Customer Service at 1-800-406-2005.
• Follow all mounting instructions. Failure to do so could result in personal injury or property damage. Manufacturer is
not responsible for damage or injury caused by incorrect installation.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
VEUILLEZ LIRE TOUTES LES INSTRUCTIONS AVANT D’UTILISER CE CHARGEUR.
• Pour une utilisation dans un endroit sec uniquement.
• Utilisez uniquement avec les piles ONEPWR
MC
-
•
• Ne tirez pas et ne transportez pas le chargeur par son cordon, n’utilisez pas le cordon comme une poignée et ne le tirez pas contre
des arêtes ou des bords tranchants. Tenez le cordon éloigné des surfaces chaudes.
•
•
• Suivez toutes les instructions portant sur la charge. Ne chargez pas le bloc-piles à des températures autres que celles indiquées
dans les instructions de charge. Toute charge inappropriée ou à des températures hors de la plage indiquée présente des risques
d’endommager la pile en plus d’augmenter les risques d’incendie.
•
•
n’est pas responsable des dommages ou des blessures causés par une installation incorrecte.
CONSIGNES DE SÉCURITÉ IMPORTANTES
CONSERVEZ CES INSTRUCTIONS
DUAL BAY CHARGER CHARGEUR DOUBLE BAIE
©
MAINTENANCE
OPERATION
ASSEMBLY
APPLICATIONS
• Charging ONEPWR™ Lithium Ion Batteries.
• -
cordance with federal regulations, the battery does not come fully charged.
• Make sure the power supply is normal household voltage, 120 volts, AC
• Do not place the charger in an area of extreme heat or cold. It will work
best at normal room temperature.
• Plug the charger into a power outlet.
• Attach the battery pack to the charger by aligning the ribs on the battery
pack to the grooves in the charger. Slide the battery pack into the charger.
• The battery pack will become slightly warm to the touch while charging. This
is normal and does not indicate a problem.
• When charging, the lights on the battery will illuminate to show the state
•
service for support.
• When the charge is complete the lights on the battery and charger will turn off.
• To remove the battery pack from the charger, press the latches and pull up on the battery pack.
• During charging, the pack and ambient temperature should be between 41 to 86°F (5 and 30°C).
• The charger will sense if the pack, or ambient temperature, is too cold or too hot, and will return an error code (red
light will remain on) and not charge the pack until ambient temperature is reached.
• Do not disassemble charger. Do not modify or attempt to repair the charger. This charger has no serviceable parts. Call
Customer Service at 1-800-406-2005.
1.
where, when mounted, it can be plugged into an outlet
that is easily accessible and out of the reach of children.
2.
Use only the power cord supplied with the kit. Wrap excess
cord length around cord wrap found on the back of charger.
3.
Remove the charging indicator plate, as shown in Figure 1,
and align the mounting holes with the center of the stud.
the bottom screw (2).
5. Place the reversible charging indicator plate back on the charger.
6. Plug in the charger. If you have problems, remove the plug from the wall socket.
7. Store the batteries by sliding them into the charger and pushing them down to secure them. IMPORTANT: Always ensure
-
age or result in personal injury.
-
chemicals, and bleach or bleach containing products, etc., can cause a short circuit in the battery pack. If your
immediately perform the following steps:
• Wear appropriate personal protective equipment, including eye protection and rubber gloves.
•
regular tap water. Do not place more than two packs in the bucket.
•
•
additional instructions on the proper disposal of the exposed battery pack(s).
Les liquides corrosifs ou conducteurs, comme l’eau salée, le
chlore, certains produits chimiques industriels, les agents de blanchiment, les produits contenant des agents de blanchiment, etc., peuvent
causer un court-circuit dans le bloc-piles. Si le bloc-piles est exposé à un liquide corrosif ou conducteur, ne pas tenter de l’utiliser ou de
• Porter le matériel de protection individuelle approprié, dont des lunettes de protection et des gants en caoutchouc.
•
du robinet. Éviter de placer plus de deux blocs dans le seau.
• Placer le seau à l’extérieur dans un endroit hors de la portée des enfants et des animaux, loin des bâtiments, des garages,
•
2005 pour obtenir des directives supplémentaires sur l’élimination adéquate du ou des blocs-piles exposé(s).
MODE RED LED ON CHARGER
WHITE LED ON
CHARGER
ACTION NEEDED
POWER
Without Battery Pack On for 3 seconds On for 3 seconds Ready to charge battery pack
TESTING
ON OFF
When battery pack reaches
normal temperature, charger
begins charge mode
COLD Battery Pack ON OFF
When battery pack reaches
normal temperature, charger
begins charge mode
DEFECTIVE
Defective Flashing OFF
Battery pack or charger is
defective
• If defective, try to repeat the conditions a second time by removing and reinstalling the battery pack. If LED status repeats a second time, try
charging a different battery.
• If a different battery charges normally, dispose of the defective pack
• If a different battery also indicates “Defective”, the charger may be defective.
CHARGING
depending on charge level
OFF Flashing Battery is being charged
Charged – lights will go off OFF On for 15 seconds
Charging is complete; charger
maintains charge mode
If this product is not as warranted, contact TTI Floor Care North America Customer Service at 1-800-406-2005. Please have
available the proof of purchase and model number for the warranted product. Failure to register the product does not diminish
product warranty rights.
WHAT THIS LIMITED WARRANTY COVERS: This limited warranty provided by Royal Appliance Mfg. Co., doing business as TTI Floor Care
North America (referred to hereafter as “Warrantor”) applies only to products purchased in the U.S. (including its territories and
possessions), a U.S. Military Exchange, or Canada. When used and maintained in normal household use and in accordance with
the User Manual, your ONEPWR charger is warranted against original defects in material and workmanship for three years from
the date of original purchase (the “Warranty Period”). If Warrantor determines that the issue you are experiencing is covered
under the terms of this warranty (a “covered warranty claim”), we will, at our sole discretion and free of charge (subject to the
cost of shipping), either (i) repair your product, (ii) ship you a replacement product, subject to availability; (iii) in the event that
the applicable parts or replacement are not reasonably available, ship you a similar product of equal or greater value; or (iv)
on the original sales receipt. Parts and replacements may be new, refurbished, lightly used, or remanufactured, in Warrantor’s
sole discretion.
WHO THIS LIMITED WARRANTY COVERS: This limited warranty extends only to the original retail purchaser, with original proof of
purchase from Warrantor or an authorized dealer of Warrantor products, in the U.S., U.S. Military Exchanges, and Canada.
WHAT THIS LIMITED WARRANTY DOES NOT COVER: This warranty does not cover use of the product in a commercial operation (such as
maid, janitorial, and equipment rental services, or any other income-generating activity); improper maintenance of the product;
the product if it has been subject to misuse, negligence, neglect, vandalism, or the use of voltages other than that on the data
plate of this product. This warranty does not cover damage resulting from an act of God, accident, owner’s acts or omissions,
service of this product by other than Warrantor or a Warrantor authorized service provider (if applicable), or other acts beyond
the control of Warrantor. This warranty also does not cover use outside the country in which the product was initially purchased,
or resale of the product by the original owner. Pick-up, delivery, transportation, and house calls are not covered by this warranty.
or the use of products, parts, or accessories which are either incompatible with this ONEPWR charger or adversely affect its
operation, performance, or durability. Normal wear items (if applicable) are not covered under this warranty.
OTHER IMPORTANT TERMS: This warranty is not transferable and may not be assigned; any assignment made in contravention of this
prohibition is void. This warranty shall be governed and construed under the laws of the state of North Carolina. The Warranty
Period will not be extended by any replacement of batteries or parts or repair performed under this warranty.
Some states do not allow the exclusion or limitation of incidental or consequential damages, disclaimers of implied warranties,
SERVICE INFORMATION & LIMITED WARRANTY FOR ONEPWR BATTERIES
COMPATIBLE BATTERY PACKS
ONEPWR
™
Battery Packs
Battery: Model #
2.0 Ah
3.0 Ah
4.0 Ah
8.0 Ah
WARNING:
shock, route cord properly, avoiding loops, is out of the reach
of children, and where they cannot get snagged or pulled.
WARNING:
If you hit metal, stop immediately and
contact an electrician.
Loading ...
