Loading ...
Loading ...
Loading ...
5
ASSEMBLY.......................................................
Assembly Instructions:
Unpack the heater and remove all parts from the packaging.
For ease of assembly, place the heater upside down or on its side on a soft surface which will not
scratch the unit. Use one hand to hold it in place.
Place the bowlegged castor-mounting plate in the front and put straight castor-mounting plate in the
end.
1. Unscrew nut and washer and nut. (Fig B-1)
2. Attach casters to metal plates with washer and nut (Fig B-2)
3. Place the bowlegged metal plate and wheel assembly between the last two fins at each end of the
heater as shown in Fig B-3,4,5.
4. Attach the plate and wheel assemblies onto the heater with the U bolts and wiring nuts supplied as
shown in Fig B-3,4,5
5. Remove the wing nut from the U bolt and insert the U bolt through the holes in the plate/wheel
assembly as shown, reattach the wing nut and tighten firmly (Fig B-6). Repeat this procedure on the
opposite side.
Location of the Heater:
1. Turn the heater upright. Ensure legs are correctly installed and level.
2. Place heater on a flat and stable surface. Setting the heater on an incline or decline may cause
damage to the unit and create a hazardous situation.
OPERATING INSTRUCTIONS____ _______........
To operate, connect to a properly polarized outlet only. Ensure the unit is in the OFF position.
Match wide blade of plug to wide slot and fully insert. Be sure to plug into a 120V AC, 60Hz
outlet. Note: When the heater is plugged in, the power indicator will be illuminated until it
is turned off and unplugged.
Loading ...
Loading ...
Loading ...