Loading ...
Loading ...
Loading ...
9
BLOWER OPERATION
MAINTENANCE
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Make sure the collection tank is empty before using as a blower.
3. Remove hose from the vacuum port. Remove noise diffuser from blower port.
4. Insert the larger end of the hose into the blower port on the back side of the power head. (Fig. 2)
5. Fit the desired attachment to the hose. (Fig. 3)
6. Verify that the power switch is in the ‘O’ OFF position before plugging the power cord into the
outlet. (Fig. 4 & 5)
7. Before turning ON the vac, rmly hold the loose end of the hose. Turn the motor on by pressing
the switch to the ‘I’ ON position. (Fig. 6)
8. Once you have completed blowing, ip the power switch to the 'O' (OFF) position and unplug
the power cord from the outlet. (Fig. 7)
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Disconnect the hose from the vacuum. (Fig. 2)
3. Undo the latches and remove the power head from the collection tank. (Fig. 3) Place power
head on a soft, clean surface upside down.
4.
Clear all dirt or debris from the collection tank and hose
.
(Fig. 4)
2
4
3
5
1
7
6
2
4
1
3
Emptying the Collection Tank
Loading ...
Loading ...
Loading ...