Loading ...
Loading ...
Loading ...
8
LIQUID VACUUM OPERATION
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION ENTITLED
‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE
GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-
BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR GUN POWDER.
TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT
VACUUM TOXIC MATERIALS.
WARNING: DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE PLUG IS
DISCONNECTED BEFORE CHANGING THE FILTERS.
LIQUID VACUUMING
1. Verify that the power cord is disconnected from the outlet (Fig. 1). Make sure that the collection
tank is clean and free from dust and dirt.
2. Remove cartridge lter, then carefully install the foam wet lter over the lter cage and place the
power head back on the collection tank. For lter installation instructions, see page 11.
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
OPERATING INSTRUCTIONS: WET VACUUMING
3. Fit the desired nozzle to the vacuum hose. (Fig. 2)
4. Verify that the power switch is in the ‘O’ OFF position before plugging the power cord into the
outlet. (Fig. 3)
5. Turn the motor on by pressing the switch to the ‘I’ ON position. (Fig. 4)
6. Once you have completed vacuuming, ip the power switch to the 'O' (OFF) position and
unplug the power cord from the outlet.
7. After use, empty the collection tank by unscrewing the drain cap. Drain liquids into a suitable
receptacle or drain. (Fig. 5) Remember to ret the drain cap to the collection tank.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
in the liquid; leave a gap at the tip of the nozzle opening to allow air inow. The machine is tted
with a oat valve that stops the suction action when the collection tank reaches its maximum
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue
vacuuming, ret the collection tank with the drain cap. After wet vacuuming, turn the machine off
and remove plug from power supply. Empty the collection tank, clean and dry the inside and
outside before storage. REMEMBER! The foam wet lter must be removed after wet vacuuming
and a cartridge lter must be installed before dry vacuuming again.
2
4
5
1 3
Loading ...
Loading ...
Loading ...