Loading ...
Loading ...
Loading ...
11
4. Install cleaned or new lter as instructed above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet lters should be removed and allowed to air dry for 24 hours before installing onto the lter
cage.
IMPORTANT! Clean or change the cartridge lter regularly for best performance.
ALWAYS USE CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without the
cartridge lter, the motor will burn out and the warranty will be voided. Always keep spare lters on
hand.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM THE COLLECTION TANK.
Installing Foam Wet Filter
1. Verify that the power cord is disconnected from the outlet. (Fig.1)
2. Remove power head and place in upside down position. Follow instructions to remove cartridge
lter.
3. Carefully slide foam wet lter down over the lter cage making sure the cage is completely
covered. (Fig. 2 & 3)
4. Place the power head onto the collection tank.
Cleaning Foam Wet Filter
1. With the removed power head in an upside down position, carefully remove foam wet lter. (Fig. 4)
2. Use a mild soap and water solution to wash foam wet lter and rinse with clean water. (Fig. 5)
3. Allow lter to air dry before installing and using again.
INSTALLING & CLEANING FOAM WET FILTER
2 3 4
5
1
Loading ...
Loading ...
Loading ...