Loading ...
Loading ...
Loading ...
8 49-1000588 Rev. 0
UNPACKING REFRIGERATOR
INSTALLATION INSTRUCTIONS
ENGLISH
IMPORTANT: Handle with care when moving refrigerator to
avoid either damaging the refrigerant tubing or increasing the
risk of a leak.
IMPORTANT: When moving the refrigerator, never tilt it
more than a 45° angle. This could damage the compressor
and the sealed system. If the refrigerator has been placed
in a horizontal position for any period of time, wait 24 hours
before plugging in the refrigerator to allow the refrigerant to
settle.
1. Remove all packaging material. This includes the
corrugated base and all adhesive tape holding the
refrigerator accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the refrigerator.
3. If your refrigerator comes with smooth or stainless steel
doors, please remove the clear film before turning it on for
the first time. When removing the film, do not pull the film
straight down as this could result in misaligned doors.
4. It is normal for the freezer door to be positioned slightly
higher than the top of the cabinet when the refrigerator
is first installed. This positioning is done at the factory to
ensure a proper gasket seal once the door is weighted with
food items.
WARNING
Explosion and Fire Hazard
Do not puncture refrigerant tubing.
Follow handling instructions carefully.
Flammable refrigerant used.
Failure to do so can result in death, explosion or fire.
LEVELING REFRIGERATOR
• Your refrigerator has two leveling legs that are located
in the front bottom corners of your refrigerator. After
properly placing your refrigerator under its final position,
you can level your refrigerator.
• Leveling legs can be adjusted by turning them
clockwise to raise your refrigerator or by turning them
counterclockwise to lower your refrigerator.
The refrigerator door will close easier when the leveling
legs are extended.
PROPER AIR CIRCULATION
• To ensure your refrigerator works at the maximum
efficiency it was designed for, you should install it in a
location where there is proper air circulation, plumbing and
electrical connections. Your refrigerator is not designed to
òóèõä÷èìñ÷èðóèõä÷øõèöåèïòú& ȚϤ!&ȚÌ¥òõäåòùè! ȚÏ
¤#'ȚÌ¥
• Do not install your refrigerator in any location not properly
insulated or heated, e.g. garage, etc. Keep out of direct
sunlight and away from heating sources such as radiators,
heaters, and cooking appliances.
• The following are recommended clearances around the
refrigerator:
Sides……………0” (0 mm) Top..................0” (0 mm)
Back..................2” (50mm)
LowerRaise
READ AND SAVE THESE INSTRUCTIONS
Loading ...
Loading ...
Loading ...