Loading ...
Loading ...
Loading ...
11
OPERATING INSTRUCTIONS
PRIMING THE EASY-BREW ESPRESSO MACHINE
The unit must be primed before first use and after extended periods of disuse when the unit
goes completely dry. This will push water into the unit’s internal parts and release air from
inside the pump. To prime, follow these steps:
1. Fill the water reservoir up to and not exceeding the MAX fill line.
2. Place a heatproof cup or mug on the coaster set over the drip tray. Make sure the steam
control knob is set to OFF.
3. Plug in the unit and press the POWER button. The button will illuminate, and the SINGLE-
SHOT, DOUBLE-SHOT, and MANUAL coee buttons will slowly pulse as the unit heats.
When heating is complete, the buttons will illuminate solid, indicating they are ready for
use.
4. Press the SINGLE-SHOT button. The unit will start pumping water through its internal parts
and a small amount of water should dispense into the cup. NOTE: The unit may produce a
loud noise when pumping water for the first time as the air is released inside. This is normal
and should stop after a few seconds.
5. Remove the cup from the drip tray and discard the water. The unit is now primed.
PREHEATING
After priming and after brief periods of disuse (a week or so), it is recommended to preheat
the unit. This will ensure the water is fully drawn into the machine, so the proper amount of
coee dispenses when making your espresso. To preheat the unit, repeat the steps under
PRIMING THE EASY-BREW ESPRESSO MACHINE. A larger amount of water will dispense into
the cup, indicating the water is able to completely pump through the unit and the unit is ready
for use. After the first use, preheating is NOT necessary if you use the unit daily.
Loading ...
Loading ...
Loading ...