Loading ...
Loading ...
Loading ...
16
• The hand held shampoo nozzle is ideal for cleaning sofas, chairs, stairs and car interiors.
• The carpet shampoo nozzle is ideal for cleaning carpets.
DISASSEMBLING THE WET/DRY SHAMPOO VAC
NOTE: SOME LIQUID MAY REMAIN IN THE TUBES AFTER USING THE PRODUCT FOR
LIQUID OR SHAMPOO CLEANING. DISASSEMBLE THE VACUUM OUTDOORS OR OVER A
SINK AS THERE MAY BE SOME LEAKAGE.
To disassemble the shampoo vacuum, follow the steps below.
1. Remove the cleaning solution tube from the power head by pressing down on the red latch.
Disconnect the hose from the vacuum.
2. Disconnect the accessories and/or telescopic wand from the remote control handle,
remembering to disconnect the delivery tubes rst, if the carpet or hand held shampoo nozzles
are attached.
MAINTENANCE
WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM COLLECTION TANK.
IMPORTANT! Clean or change the lter regularly for best performance. ALWAYS USE THE
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without the cartridge lter,
the motor will burn out and the warranty will be voided. Always keep spare lters on hand.
NOTICE! The lters included are made of high quality materials designed to stop small dust
particles. The cartridge lter should be used for dry pick-up only. A dry cartridge lter is necessary
to pick up dust. If the cartridge lter is wet, it will clog quickly and be very dicult to clean. Handle
the lter carefully when removing it for cleaning and replacing it. Check the lters for tears or small
holes. A small hole can let dust pass through and out of the lter. Do not use a lter with holes or
tears; replace it immediately.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Press down the latch on the cleaning solution outlet coupling and unplug the delivery tube from
the vacuum. Then disconnect the hose from the vacuum (Fig. 2).
3. Undo the latches and remove the power head from the collection tank (Fig. 3). Place the power
head on a soft, clean surface upside down.
4. Clear all dirt or debris from the collection tank and hose into a proper waste container (Fig. 4).
5. Clean or replace the lters (Fig. 5).
6. Check the hose, attachments, and power cord to ensure that they have not been damaged.
7. Place the power head back onto the collection tank and secure latches.
EMPTYING THE COLLECTION TANK
3
4
1
2
5
Loading ...
Loading ...
Loading ...