Loading ...
Loading ...
Loading ...
10
8. Optional: For improved dust ltration, t the dust bag ange onto the inlet port, taking care not
to damage the bag (Fig. 9).
NOTE: The dust collection bag is for dry pick-up only.
9. For wet vacuum cleaning, remove the cartridge lter, and install the supplied foam wet lter.
See page 18 for the foam wet lter installation instructions (Fig. 10).
10.Place the power head back on the collection tank aligning the top section with the latches, and
snap into place (Fig. 11).
11.Ensure the cleaning solution tube is securely tted to the cleaning solution inlet coupling on the
rear side of the power head. Ensure the other end of the tube is securely tted onto the cap of
the cleaning tank (Fig. 12).
12.A cleaning solution delivery tube runs along the hose with a threaded connector and connector
cap at each end. Insert the locking end of the hose into the vacuum port of the collection tank
and turn clockwise to lock into place. Insert the threaded connector on the end of the delivery
tube into the cleaning solution outlet coupling on the front of the power head (Fig. 13).
13.Insert the other end of the hose into the remote control handle. Align the marking “ ” on the
hose with the middle of the remote control handle. Rotate the hose and ensure the marking
“ ” is aligned with the marking “ ” on the remote control handle. Connect the delivery tube
cap to the remote control handle (Fig. 14 & 15).
14.Choose the desired accessory and/or the telescopic wand and insert it onto the remote control
handle (Fig. 16).The air ow regulation (
①
) on the remote control handle allows you to
manually change the amount of vacuum suction (Fig. 17).
NOTE: If the suction power is too high when cleaning, rotate the air ow regulation
counter-clockwise to decrease the suction power.
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will t in a polarized outlet only one way. If the plug does not t fully in the outlet,
reverse the plug. If it still does not t, contact a qualied electrician to install the proper outlet.
Do not change the plug in any way. Double insulation eliminates the need for the three wire
grounded power cord and grounded power supply system.
PROGRAMMING THE REMOTE CONTROL HANDLE
NOTE: The programming of the remote control handle has been preset and is ready to be used in
both vacuum and detergent mode. Reset the remote control handle using the steps below if unable
to operate in vacuum mode.
1. Ensure the vacuum is plugged into the power outlet.
2. Switch the on/o switch to the “I” ON position.
3. Locate the detergent mode button on the power head indicated by the following symbol .
4. Press and hold the detergent mode button until the indicator light illuminates continuously
(Fig. 18).
5. With the light is on, press and hold the detergent mode button on the remote control handle
until the indicator light on the power head starts to ash. The remote control handle is now
programmed to vacuum and you should be able to operate in both detergent and vacuum
modes (Fig. 19).
6. If the indicator light does not ash, repeat steps 1 to 5.
Loading ...
Loading ...
Loading ...