Loading ...
Loading ...
Loading ...
_kCAUTION; Before performing any ser-
vice or adjustments:
. Release operator presence control bar.
° Make sure the blade and all moving
parts have completely stopped.
° Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with plug,
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibility that objects will
be thrown out of the rear of the mower
into the operator's mowing position. If the
deflector becomes damaged, it should be
replaced.
DISCHARGE GUARD (IF EQUIPPED)
The discharge guard, attached to the side
discharge opening of your lawn mower, is
provided to prevent the possibility of iniury
resulting from objects being thrown out of
the discharge opening into the operator
mowing position. If the discharge guard
becomes damaged, it should be replaced.
TO ADJUST HANDLE
"2 POSIT_ON" HANDLES
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle,
• Remove upper handle and all parts at-
tached to lower handle,
• Remove hairpin cotters from lower
handle bracket mounting pin.
• Squeeze lower handle in to remove it
from mounting pins.
• Turn lower handle over to raise or lower
handle.
• Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
• Reassemble hairpin cotters onto pins.
,, Reassemble upper handle and all parts
removed from lower handle.
TURN LOWER
HANDLE OVER
TO ADJUST HEIGHT
3 POSITION "EZ" HANDLES
The handle on your lawn mower has three
(3) height positions - adiust to height that
suits you.
• Remove knob and carriage bolt on one
side of the lower handle.
° While holding handle assembly, remove
knob and carriage belt from opposite
side, align hole in handle with desired
hole in handle bracket and reassemble
bolt and knob and tighten securely.
• Align opposite side of handle with same
positioning hole and secure with bolt and
knob.
High ._ Bolt
J
Knob
/"Handle
adjustment
cket
27
Loading ...
Loading ...
Loading ...