Loading ...
Loading ...
Loading ...
CAUTION
For proper dispenser operation,
recommended water supply pressure
should fall between 30psi and 100psi.
Excessive pressure may cause the
system to malfunction.
IMPORTANT
The ice maker is turned on at the
factory so it can work as soon as the
refrigerator is installed. If it is not pos-
sible to connect a water supply, set the
ice maker’s On/O feature to O either
by using the display or by pressing
the switch (features vary by model).
Otherwise, the ice maker’s fill valve may
make a loud chattering noise when it
attempts to operate without water.
20
AUTOMATIC ICE AND WATER DISPENSER
NOTE
The water dispenser has a built-in de-
vice that shuts o the water flow after
two minutes of continuous use. To reset
this shuto device, simply release the
dispenser paddle.
Ice Maker Operation & Care
After the refrigerator is installed properly
and has cooled for several hours, the ice
maker can produce ice within 24hours.
The ice maker will fill the ice bin from the
rear. Dispense some ice to force the ice
forward in the bin. This will allow the bin
to fill completely.
Ice Maker and Storage
Bin Capacity
Both counter depth and standard depth
model ice makers should produce 3.2 to
3.7 lbs of ice per 24 hours depending on
usage conditions. The counter depth ice
bin will hold about 4 lbs of ice, and the
standard depth ice bin will hold about 5
lbs of ice.
NOTE
After the initial 26 oz (750 ml), water
will remain room temperature until the
tank has refilled and been given enough
time to chill the next 26 oz (750 ml) of
water. May take up to 8 hours to chill.
Using the ice maker
after installation
Before making ice for the first time, be
sure to prime the water supply system.
Air in new plumbing lines can result in
two or three empty ice maker cycles.
Furthermore, if the system is not flushed,
the first ice cubes may be discolored or
have an odd flavor.
Priming the water supply system
Dispenser
1. Hold a glass against the paddle for
about 4 minutes to purge air from
the system.
2. Continue dispensing at least 1 full
gallon (3.6 L) of water and discard.
Turning the ice maker on and o
Press and hold Ice Maker on the external
appliance control display for 3 seconds to
turn ice production on and o.
Before dispensing water for the first
time, be sure to prime the water supply
system. If the system is not flushed, the
first glasses of water may have discolored
water or have an odd flavor.
Loading ...
Loading ...
Loading ...