Loading ...
Loading ...
Loading ...
15
WATER SUPPLY CONNECTION
To Connect Water Tube to
Household Water Supply
1. Disconnect
refrigerator
from electrical
power source.
2. Place the end
of the water
supply line
into a sink or
bucket. Turn
ON the water
supply and
flush the supply
line until the
water is clear.
Turn OFF the
water supply at the shuto valve.
Place 7/16" wrench
here. Do not turn.
Place 1/2" wrench
here. Turn
clockwise.
6. Replace the connected tubes into
the clips and lock the clips back
in place to keep the tubing in the
right position.
7. Turn ON the water supply at
the shuto valve and tighten any
leaky connections.
8. Reconnect refrigerator to an
electrical power source.
9. Ensure the ice maker is turned ON.
10. Purge air from the Ice and Water
Dispenser System by operating the
water dispenser for 3-4 minutes. This
will require dispensing several glasses
of water.
3. Open the locking
clips and grab
the water line
coming from
the refrigerator.
Remove the
plastic cap
from the water
inlet fitting and
discard the cap.
4. If using (recommended) stainless
steel braided tubing - the nut and
ferrule are already assembled on
the tubing. Slide the compression
nut onto the water inlet fitting and
finger tighten.
5. Using ½" and 7/16" wrenches (one
to hold the household water line nut
and the other to hold the water inlet
fitting nut), tighten a half turn with
the wrench. DO NOT over tighten.
Water
inlet
fitting
Plastic
tubing
to
water
valve
6 ft. (1.8 Meters) Stainless
Steel water line from
household water supply line
Connection to Household Water Supply
with 1/4" compression
fitting
Plastic
Cap
Remove
plastic cap
from water
inlet fitting
Water Inlet
Brass
Fitting
¼ inch
plastic tube
to water
valve
To
household
water
supply
To
unit
water valve
Loading ...
Loading ...
Loading ...