Loading ...
Loading ...
Loading ...
There is a locking lever on the left end of the socket.The socket is relaxed
when standing up.Insert or remove the component under test at this
time.When turned down, the socket is locked and tested
After inserting the element under test and locking.Press 【TEST】 button to
test.The tester automatically identifies the pin name of the component and
the test point where it is located, and displays it on the screen
When testing 2-pin components, it can be inserted into any two holes with
different labels in the 1-2-3 area.No need to distinguish
When testing 3-pin components, it can be inserted into any three holes with
different numbers in the 1-2-3 area.No need to distinguish
The K-A-A jack is a special area for withstand voltage testing.There is about
30V DC high voltage inside.K is positive and A is negative. It is used for
withstand voltage test and cannot be mixed.The positive electrode of the
component under test, such as the Zener diode, is inserted into A, and the
negative electrode is inserted into K
1. Discharge the capacitor before measuring the capacitor,
otherwise it may burn the instrument
2. Live test is not recommended
NOTE ！
For wired testing, you should use test wire with MCX plugs to
connect to the instrument
There are 3 MCX coaxial sockets evenly distributed on the top surface, and
their outer rings are connected to the same ground.The uses are:
【IN(0~16V)】⸺Test voltage input port, the core wire is positive, and the
maximum measured voltage cannot exceed DC16V
【PWM】⸺PWM square wave signal output port, output square wave signal
with adjustable pulse width
【DSO】⸺oscilloscope test signal input port, the maximum measurement
voltage shall not exceed ±40V (probe X10 shall not exceed ±400V)
【 Signal Interface 】
【4.3】 Signal Interface
PAGE
Loading ...
Loading ...
Loading ...