1. Home
  2. Chef
  3. Chef CFG504SALP User Manual
  4. Page 22

User Manual - Page 22

For CFG504SALP. Also, The document are for others Chef models: CFE532WA, CFE536WA, CFE536SA, CFE535WA, CFE537WA, CFE547WA, CFE547SA, CFG504WA, CFG504SA, CFG503WA, CFG515WA, CFG517WA, CFG517SA

Loading ...
Loading ...
Loading ...
Wiring connection for gas cooker
To allow for disconnection of the appliance after installation,
the plug must be accessible after installation, or a functional switch
must be provided near the appliance in an accessible position.
If the supply cord is damaged, it must be replaced by the
manufacturer,itsserviceagentorsimilarlyqualiedpersons
in order to avoid a hazard.
Gas connection
Read these points before connecting to the gas supply:
• Thecookerinletconnectionpointhasa½”BSPexternal
thread. See Diagram below
• ANGregulatororaLPGtestpointttingissupplied
• Itisrecommendedtottheregulatorortestpointttingto
the appliance connection point, then fit either hard piping
orahighlevelexibleconnection(AS/NZS5601.1
clauses 5.9 and 6.10.1.9) which is then attached to the
consumer hard piping
• Ensureinstallationallowswithdrawalofappliance.
Restraining Device
Anchor Points
Gas
Connection Point
150mm
650mm
Operation on universal LPG/propane
1. The appliance inlet fitting provided MUST be orientated
so that the pressure nipple is accessible
2.Theinletttinghas½”BSPinternalthreadattheinlet
and outlet.
Operation on SNG
• IfthecookeristobeusedwithSNG,thenthegrillburner
MUST be modified by the replacement of the shutter,
which fits into the throat of the grill burner
• Aconversionkitcanbeobtainedbycontactingthe
Customer Care Centre
Restraining Device
Anchor Points
Grill Shutter
Pressure test point
NG Regulator
1/2” BSP
Internal Thread
Connection
Gas
Point
150mm
650mm
Gas Flo
w
WARNING
1. Disconnect electric power before removing control panel
2. Remove the control panel
3. Remove the existing NG shutter securing screw (refer to
diagram above) and slide upwards to disengage from
grill burner
4. Slide the SNG shutter into position and secure with screws.
Testing the gas cooker
WARNING
warning
You MUST test the cooker after installation, before you hand
it over to the customer.
You MUST have a manometer and a connecting tube.
installation
22 INSTALLATION Chef 540 Upright Cooker
Loading ...
Loading ...
Loading ...