Loading ...
Loading ...
Loading ...
8 BISSELL.com BISSELL.com 9
WARNING To reduce the risk of fire due to internal component damage use only BISSELL cleaning products
intended for use with this appliance.
Sanitizing with Spot Mode
In Spot Mode, use BISSELL® Hard Floor Sanitize Formula to sanitize floors after tough messes like pet
accidents, or give areas extra attention with BISSELL® Multi-Surface or Natural Pet Formulas.
Note: You can sanitize three to four different areas around your home with a single tank.
HARD FLOOR
SANITIZE
1. Wipe up the mess with a
disposable towel.
2. Add BISSELL Hard Floor
Sanitize Formula.
3. Place the robot in the center
of the area you want to clean.
x2
40 inches
(1m)
40 inches
(1m)
40 inches
(1m)
40 inches
(1m)
4. To start cleaning, press
the play/pause button twice
or select “Spot” mode in the
BISSELL Connect App.
5. The robot will clean in a
square pattern covering an
area approximately 40” x 40”
for about 5 minutes. It will
beep when finished and return
to the dock.
6. Use caution when walking
through the area as the floor
may be slippery. Allow to
remain wet for 5 minutes.
Maintaining the Mop Pads and Debris Trap
1. Turn the power switch OFF.
Press the button on top of the
mop tank and pull to remove.
Place tank upside down on a
soft surface.
2. Firmly pull up on the mop
pads to remove from mop pad
drivers. Replace mop pads if
damaged.
3. Machine wash separately in
warm water.
4. To reattach, use the middle
hole on the pads to align with
the driver.
5. Empty the dirt bin after
each use, including after
mopping.
6. Push the tab on the top of
the mop tank to open the dirt
bin and empty it.
7. Lift up on the filter cover
located on top of the tank and
remove the filter. Brush off
dust and debris from the filter.
WARNING To reduce the risk of fire, turn the power switch OFF before performing maintenance or
troubleshooting checks.
Mop Mode (continued) Mop Mode (continued)
Manual Cleaning
1. Turn the robot ON. 2. Start the robot automatically
with the app, or manually by
pressing the play/pause button.
3. When the robot is finished
cleaning, it will return to the
dock. If you want it to return
to the dock before cleaning is
complete, press the play/pause
button, then press home.
Loading ...
Loading ...