Loading ...
Loading ...
Loading ...
LAUNCH
16
communication and 12V power through a standardized DLC.
A vehicle not equipped with an OBD II management system supplies
communication through a DLC connection, and in some cases supplies 12V
power through the cigarette lighter receptacle or a connection to the vehicle
battery.
1. For OBDII vehicles, use the included diagnostic cable (HDB15F to HD15F
data cable + HD15M to OBD II adaptor) to connect the VCI to the vehicle’s DLC
port.
1. VCI
2. HDB15F to HD15F data cable
3. HD15M to OBD II adaptor
4. Vehicle’s DLC port
2. For non-OBDII vehicle, refer to the above figure to make connection.
1. Select the appropriate adaptor from the non-16pin adaptor kit (sold
separately) according to the vehicle’s DLC port type (4).
2. Loosen the captive screws of the HDB15F to HD15F data cable (2) and
disconnect the HD15M to OBD16 adaptor (3) from the data cable.
3. Connect the data cable (2) with the target adaptor on the above figure and
tighten the screws. Other steps shall also apply.
Note: If the pin of the DLC is damaged or has insufficient power, you can get
power via either of the following methods:
A. Battery Clamps Cable (not included):
Connect one end of the battery clamps cable to the power jack of the diagnostic cable,
Loading ...
Loading ...
Loading ...