Loading ...
Loading ...
Loading ...
Sears recommends the following accessories
ITEM CAT. NO. ITEM CAT, NO.
Work Bench .......................................... See Catalog
Motor Pulley (Four Step) 1/2" Bore ......... See Catalog
Motor Pulley (Four Step) 5/8" Bore .......... See Catalog
Drill Chuck 1/2" Capacity with
No. 1 MT. Shank .............................. See Catalog
Screw Center with No. 1 M.T. Shank ....... See Catalog
Ball Bearing Center with
No. 1 M.T. Shank ............................... See Catalog
60° Center with No. 1 M.T. Shank ........... See Catalog
Face Plate, 4" Dia. with 3/4"-!6 Thread
9 holes ...................................................... 9-2489
9" Dia. Sanding Disc only with 3/4"-16
Thread .................................................... 9-24906
Sanding Table ............................................. 9-24922
Turning Tools ........................................ See Catalog
Draw Bolt with 1/4"-20 Threads ............... See Catalog
Power Tool Know How Handbook ................. 9-29117
Bowl Turning Tool Rest ................................ 9-24903
Face Plate 6" with 3/4"-16 Thread
6 holes .................................................... 9-24904
Copy Crafter ................................................ 9-24907
Speed Reducer ..................................... See Catalog
Face Plate 4" dia. with 3/4"-16 Thread
Cast Iron, 6 holes ............................... See Catalog
Diameter Sizing Gauge ................................. 9-24909
Sears may recommend other accessories not listed in
the manual. See your nearest Sears store or catalog
department for other accessories. Do not use any
accessory unless you have received and read com-
plete instructions for its use.
trouble shooting
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH "'OFF"
AND REMOVE PLUG FROM POWER SOURCE OUTLET BE-
FORE TROUBLE SHOOTING.
TROUBLESHOOTING CHART
TROUBLE
Motor will not run.
PROBABLE CAUSE
1. Defective On-Off switch,
Defective switch cord.
Defective switch box receptacle.
2, Motor protector Open,
(only if your motor is
equipped with an
overload protector).
3, Burned out motor
REMEDY
1, Replace defective parts before using Lathe
again.
2, Reset protector when motor has cooled,
3. Consult Sears Service. Any attempt to repair this
motor may create a HAZARD unless repair is
done by a qualified service technician. Repair
service is available at your nearest Sears Store,
Lathe slows down 1, V-belt too loose 1. Adjust belt tension, see Assembly Section.
when turning
Tailstock rocks I, Brass adjusting screw is too I. Adjust screw. See Section, "Getting To Know
back and forth loose. Your Lathe".
excessively.
Headstock loose 1. Setscrew not tight, l, Tighten setscrew. See Section, "Getting To
on bed, Know Your Lathe",
Wood burns at 1, Cup center too tight or not !. Back off tailstock ran, and iubricate
taiistock end. lubricated, cup center. See Basic Lathe Operation
Section, "Spindte Turr_ing,"
31
Loading ...
Loading ...
Loading ...