Loading ...
Loading ...
Loading ...
ROTATION
CHECK SPINDLE ROTATION
The Lathe spindle must rotate counterclockwise when
viewed from the spindle end,
NOTE: Make sure the spur center is removed from the
spindle.
1. Plug the Lathe power ,cord into a properly grounded
outlet (See page 5)
2. Stand clear of the Lathe spindle and tur n the switch ON.
Notice the rotation of the spindle. If it is NOT turning
COUNTERCLOCKWISE contact your Sears Store im-
mediately before using this tool,
TERMINAL
coVER
getting to know
BACK OF TOOL
BELT GUARD
2 INDEX PIN
your b'VO Od
11spu.
CENTER
3 SPINDLE
LOCK
HOLE
lathe
7 HANDWHEEL
TAILSTOCKRAM /
1 0 CUP CENTER
8 TAILSTOCK RAM
TOOL REST
TOOL REST _"_
BASE
TOOL REST
BASE LO¢
SPINDLE
!3
SPEED
1 BELT GUARD
LOCK
1 0 ON-OFF
SWITCH
HEADSTOCK
I. BELT GUARD LOCK... Locks the hinged part of the
guard during operation.
2. INDEX PIN.,. Engages with the spindle pufley to
determine equal spacing for cuts for fluting or reeding,
or for dividing face plate work. DO NOT USE FOR
REMOVING FACEPLATES,
3. SPINDLE LOCK HOLE.., For removing faceplates or
sanding discs, insert a setscrew wrench, large na_I or
bolt in the hole to hold the spindle while unscrewing
faeep_ate or sanding disc,
4. TOOL REST BRACKET LOCK._. Clamps the tool
rest bracket to the bed,
\
BED
FOOT
)TAILSTOCK
LOCK
12 TA,LSTOCK
TOOL REST
LOCK
4 TOOL REST
BRACKET LOCK
FRONT OF TOOL
5. TOOL REST LOCK.., Clamp the too_rest to the tOOl
rest base.
6. TOOL REST BASE LOCK... Clamps the tool rest
base to the bed.
7. HANDWHEEL • . . Adjusts the tailstock ram.
8. TAILSTOCK RAM LOCK,.. Clamps the ram in the
taiistock,
9, TAILSTOCK LOCK.,-CIamPs the tailstock to the
bed,
10. 0N-0FF SWITCH
11
,, °_--=1!--= ......... i
Loading ...
Loading ...
Loading ...