Loading ...
Loading ...
Loading ...
2. Push the loop through the bottom hole in the cord
retainer.
3. Move the loop over the retaining clip (17), and pull down
until the cable attaches to the cord retainer.
8.4 EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Disconnect the machine from the power supply.
3. Open the rear discharge door and hold it.
4. Hold the grass catcher by its handle and unhook it from
the slots.
5. Close the rear discharge door.
6. Empty the grass catcher.
8.5 OPERATE ON SLOPES
WARNING
Do not mow on the slopes with incline more than 15°. If
you are not comfortable, do not mow on a slope.
• Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
• Monitor the holes, ruts, rocks, and other hidden objects
that can cause you to fall. Remove all obstacles such as
rocks and tree limbs.
• Make sure that your footing is stable. If you are out of
balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or embankments.
8.6 OPERATION TIPS
• Do not try to override the operation of the start button or
bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9 MAINTENANCE
WARNING
Disconnect the machine from power supply before
maintenance.
WARNING
Keep the engine free from grass, leaves or too much grease.
CAUTION
Use only approved replacement parts.
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
9.1 GENERAL MAINTENANCE
• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use water.
9.2 REPLACE THE BLADE
18
19
20
WARNING
Use only approved replacement blades.
WARNING
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Disconnect the machine from the power supply.
4. Turn the machine to its side.
11
English
EN
Loading ...
Loading ...
Loading ...