Loading ...
Loading ...
Loading ...
39
CHAPTER 6: PART REPLACEMENT GUIDE
CHAPTER 6: PART REPLACEMENT GUIDE
6.1 MOTOR REPLACEMENT
1) Disconnect power cord.
2) Remove the 2 screws holding the motor cover to the frame (Fig-1)
3) The cover is secured to the frame. So you will have to pull up with some force (Fig-2)
Fig-1 Fig-2
4) shows the motor area with the motor cover removed.(Fig-3)
Fig-3
5) Reverse Steps 1-3 to install a new motor cover.
6) Confirm drive belt tension is correct after replacing motor (see section 6.5)
7) Unplug the motor connector from LCB, speed sensor, cut any wire ties as needed.
8) Remove drive belt by walking belt off as moving running belt and pushing a side drive belt.
9) Remove the four motor bolts and remove motor.
10) To re-install motor, tilt motor towards front roller with motor base plate on front mounting
studs. Place drive belt on front roller and motor pulley. With force, draw the motor back, firmly
stabilizing the motor from slipping off mounting studs. Then fix mounting bolts.
11) Reverse steps 1-4 to complete. Replace any wire ties removed.
12) Test at various speeds.
Loading ...
Loading ...
Loading ...